Cleveland steamcraft 21-CET-8 User manual

Cleveland
™
Project ________________________________
Item __________________________________
Quantity_______________________________
FCSI Section ____________________________
Approval _______________________________
Date __________________________________
1333 East 179 St.,
Cleveland, Ohio,U.S.A. 44110
Tel: [phone]
Fax: [phone]
Web Site:www.ClevelandRange.com
Email: [e-mail]
STEAMCRAFT®GENERATOR STYLE
HIGH SPEED CONVECTION STEAMERS
MODEL:c21-CET-8
Cleveland Standard Features
nCooking Capacity for up to three 12˝ x 20˝ x 21⁄2˝deep
Cafeteria Pans.
nInnovative PowerPak Electric Steam Generator: One
Special Stainless Steel Fire Bar Heating Element. Strong
14 Gauge Stainless Steel Construction. Large 3.5 gallon
generator reservoir for fast steam cooking production. Fully
insulated rear mounted steam generator.
nEasy Access Generator Cleaning Port: Generator Cleaning
Port located on the outside, top of the unit. Not necessary to
remove hot panels or rack guides to access.
nGenerator Cleaning Light: Indicator Light located on the
front of the unit warns operator it is time to delime generator.
nInstant Steam Stand By Mode: Hold generator at a steaming
temperature. Allows unit to start cooking instantly.
nDurable 14Gauge, Stainless Steel Construction:
For compartment door,cavity and steam generator.
nOne 60 Minute Electro-Mechanical Timer and Switch for
manual operation: Audible signal for cooking time
completion.
nMain Power On/Off Switch: With Automatic Water Fill.
nExclusive Steam Cooking Distribution System:
Maintenance Free Exclusive Brass Steam Jets produce a high
velocity convection steam without fans. Coved Corner design
in cooking compartment distributes heat evenly, and is easy to
keep clean. Creased top & bottom enhance drainage. Cold
water condenser behind drain maintains a dry steam. Fully
insulated cooking compartment for thermal efficiency.
Removable Stainless Steel Slide Racks for easy cleaning.
nAutomatic Generator Drain: Contains a “Water Jet” Spray
Rinse Drain Cleaning Cycle to keep drain clear.
nExclusive Automatic Remote Probe Type Water Level
Control: Separate from the generator for easy access.
nExclusive “Cool to the Touch”Two-Piece Compartment
Door Design: Free floating inner door with reversible gasket
provides an air tight seal. Stainless Steel Slam/Latch Door
Latch mechanism for reliability.
nLeft Hand Door Hinging: Compartment Doors hinged on the
left, controls on the right.
nAvailable in most voltages, single or three phase only.
nStackable by using the optional (STKI) Stacking Kit and
Optional Stacking Stand (ES2130S) is available (2 units only) .
Options & Accessories
pRight hand Door Hinging, Controls on the Left (DHR)
pElectronic Timer with Compensating Load Feature (ETC)
Shall be CLEVELAND, SteamCraft

Ultra 3 , one compartment,
Counter-Type Steamer, Model 21-CET-8, ___volts, 8.5 KW, ___Hz.
Heavy duty all Stainless Steel construction. Rear mounted, insu-
lated Steam Generator with Remote Probe Type Water Level
Controls and Automatic Steam Generator Blowdown with “Water
Jet” Drain Cleaning feature.
pON/OFF Steam Switch for compartment controls (MC)
p 34" (864mm) High Stainless Steel Economy Stand, for one 21-CET-
8 (UniStand34)
p24" (610mm) High Stainless Steel Stacking Stand (UniStand25) ,
for mounting two stacked
21-CET-8 , includes 2" Stainless Steel
Mounting Spacer
p POSK Pull-Out Shelf Kit for UniStands ( P/N 111724 )
p URK Pan Rack Kit UniStands ( P/N 111726 )
pEquipment Stacking Stand Shelf Type (ES2446)
pStacking Kit (P/N 107166) includes plumbing for water, a
drain and Generator Cleaning Port Connections (STKI) (2
units only)
p4˝ Stainless Steel Legs (LF4)
pDissolve®Descale Solution, 6 one gallon container w/quart
markings (106174)
pCompartment Door Steam Shut Off Switch (SCS)
pAdditional Pan Racks for Equipment Stands (PR)
pCafeteria Pans in depths of 1˝, 21⁄2˝ and 4˝
pWater Filters
Short Form Specifications
Shown with optional
Electronic Timer
SteamCraft ®Ultra 3
COUNTER TYPE DESIGN
PRESSURELESS CONVECTION STEAMER
ELECTRIC STEAM GENERATOR, 8 KW
SECT. IV PAGE 1
0707

Compartment has capacity for:
•Three, 12˝ x 20˝ x 21⁄2˝deep Cafeteria Pans.
(NOT TO SCALE)
SECT. IV PAGE 2
0707
Litho in U.S.A.
WATER QUALITY REQUIREMENT
The recommended minimum water quality standards
whether untreated or pre-treated, based upon 10 hours of
use per day, and a Daily Blowdown, are as follows:
TOTAL DISSOLVED SOLIDS less than 60 parts per million
TOTAL ALKALINITY less than 20 parts per million
SILICA less than 13 parts per million
pH FACTOR greater than 7.5
CHLORINE less than 30 parts per million
Consult a local water treatment specialist for an on site
water analysis for recommendations concerning steam gen-
erator feed water treatment (if required), in order to remove
or reduce harmful concentrations of minerals. The use of
highly mineralized water will mean that more frequent ser-
vicing of the steam generator will be necessary. The fact
that a water supply is potable is not proof that it will be suit-
able for the generator.
ELECTRIC WATER DRAINAGE CLEARANCE
C
D
Cold water:
35 psi minimum
60 psi maximum
Two 1⁄4˝ NPT Tubing:
C1 one for Condenser
C2 one for Steam Generator
Unit comes with a
40 Mesh Water Strainer
(installation required)
11⁄4˝ N.P.T. tube
Do not connect other units
to this drain.
Drain line must be vented.
No PVC pipe for drain.
1 Ph
Volts Watts Amps Wire
208 8,300 39.9 2
220 6,974 31.7 2
240 8,300 34.6 2
3 Ph
Volts Watts Amps Wire
208 8,300 23.6 3
220 6,974 18.8 3
240 8,300 20.5 3
440 6,974 9.4 3
480 8,300 10.3 3
360 7,445 12.3 4
380 8,300 13.0 4
415 8,300 11.9 4
Right - 3”, Left - 3”, Rear - 3”
(12” on control side if adjoining
wall or equipment is over 30”
high for service access)
Contact factory for
variances to clearances.
NOTES:
Cleveland Range reserves right of design improvement or modification, as warranted.
Many regional, state and local codes exist and it is the responsibility of the owner and installer to comply with the codes.
Cleveland Range equipment is built to comply with applicable standards for manufacturers. Included among those approval agencies are UL, ULC, UL/NSF#4, CE and CSA.