Clevertronics Argonaut Square ARGOSQ Series Installation and operating instructions

1942488
V1.0
2nd August 2021
Instruction Sheet Template - V1.1 –Updated 23/11/2020
THIS PAGE IS INTENTIONALLY LEFT BLANK
240V Argonaut Square LED Emergency Light
Installation & Maintenance Instruction Leaflet
Victoria (Head Office & Manufacturing)
Website: www.clevertronics.com.au
Email: [e-mail]
Phone: [phone]
Fax: [phone]
New South Wales
Phone: [phone]
Fax: [phone]
Queensland
Phone: [phone]
Fax: [phone]
South Australia/Northern Territory
Phone: [phone]
Fax: [phone]
Western Australia
Phone: [phone]
Fax: [phone]
New Zealand
Phone: [phone]
UK OFFICE
Website: www.clevertronics.co.uk
362 Stockley Close
West Drayton UB7 9BL
Phone: [phone]
Models:
ARGOSQ-yy
Options:
Microwave Sensor Hi/Lo Control
yy = SEN
Black Body
vv = BLK
Spare Parts:
8050785
LED Panel + Clips
1330094
1330094 LED Driver - 40w Stallion, SP2, 470/270mA
1330095
LED Driver - 40w Stallion, MS-HL2, 470mA (for yy = SEN)
Important:
It is illegal for anyone, except for a licensed electrician to install or maintain this product. Before installation,
ensure that the electricity supply has been switched off and isolated. Installation must be carried out in
accordance with the relevant Building and Electrical Standards.

1942488
V1.0
2nd August 2021
Instruction Sheet Template - V1.1 –Updated 23/11/2020
Installation:
The Argonaut Square can be installed either Ceiling or Wall Mounted.
•Remove the four (4) screws holding the diffuser to the base.
•Remove the four (4) screws holding the gear tray to the base.
•Determine the cable access point. There are 2 locations on opposite sides of the fitting for cable
gland/conduit entry. Entry can also be from the back of the base. Drill out the desired cable entry
point.
Note: Only round cables are to be used with the cable gland for an IP65 seal. Keep cable
entry straight and tension free. Ensure all seals are tight.
min. wire diameter 7mm, max. 12mm.
•Drill out 4 of the mounting points in the base (see image below).
•Using the base as a guide, mark the 4 holes for mounting and one for mains access if using back
cable entry.
•Mount the base using appropriate fixings and seal these fixings with appropriate sealant (fill any
additional entry points with same sealant also).
•Route the power inside the base.
•Connect the 240VAC (L,E,N) supply to the terminal block of the gear tray.
•Install the gear tray to the base.
•Apply power to the fitting and test per the instructions.
•
NOTE:
This luminaire (with reinforced insulation between control/LED terminal and AC Supply) contains non-
user replaceable light source –to be replaced (if required) by the manufacturer or his service agent or a
similar qualified person.
Dimensions:
Driver Setting:
For non -SEN / -DD products
Trouble Shooting:
Below are a list of common problems and their possible causes.
Fault: The LED Strip is not illuminated.
Check: A.C. is connected and is turned on.
Wiring connections between the LED Driver & LED Strips