Converters.TV 15153 User manual


ID# 15153
Operation Manual

Introduction
The 4 by 2 HDMI Matrix with 4K×2K Support is capable of switching and
routing an HDMI signal fro any of its four sources to either of two
connected HDMI displays allowing any source to be be shown
independently on either display. It supports 3D, 'Deep Color' and High
Definition lossless audio for ats. Control of inputs and outputs can be easily
operated through the on-panel buttons, IR re ote control, RS-232 or Web
GUI controls
Features
• Supports Standard and High Definition resolutions up to 4K×2K
(UHD)
Supports up to 7.1 channels of High Definition audio (LPCM, Dolby
TrueHD, and DTS-HD Master Audio)
Supports 'Deep Color' up to 1080p/36-bit
Supports Internal/External EDID settings
Supports control through On-panel Buttons, IR, RS-232, and Web
GUI
Note:
1. This unit does not support HDMI to DVI conversion.
2. For playback of 4K×2K HDMI source signals, a 4K×2K capable
display and High Speed HDMI cables are required.
Applications
• Showroo display control
Educational de o
Residential and Co ercial Installation usage
Advertising display
System Requirements
HDMI source devices such as Blu-ray/DVD player, ga es consoles or
set-top boxes and HDMI equipped output display (HDTV/ onitor) and
HDMI High Speed cables.

Operation Controls
and Functions
Front Panel
1. IR Window:
Accepts the re ote control signal of this Matrix only.
2. POWER Button and LED:
Press this button to power the Matrix ON/OFF. The LED will light up when
the power is ON.
3. EDID Button and LED:
When in 'TV' ode, the unit will detect the EDID settings of the display
connected to Output A. If it detects a 4K×2K capable EDID setting it will
trans it the signal in that for at to the output ports. If no 4K×2K capable
EDID is detected then the unit will detect the EDID settings and output the
best resolution that all displays can support.
When in 'STD' ode, the unit will use it's own built-in EDID . In this ode,
the video output will be set to 1080p@60Hz and the audio at LPCM 2CH
Stereo. Use this ode if there are display proble s in TV Mode.
Note: The LED will light when in STD ode.
4. OUTPUT A/B Buttons and LEDs:
Press the 'A' or 'B' buttons to select the source (1~4) for that output, the
corresponding LED will light to indicate the selected source.
ack Panel
1. INPUT 1/2/3/4:
Connect to HDMI equipped source devices such as DVD/Blu-ray players,
set-top boxes or ga es consoles.
2. OUTPUT A/B:

Connect to an HDMI TVs/displays or onitors for display of the selected
source signal.
3. RS 232:
Connect to a PC/laptop or RS-232 control syste with a D-sub 9-pin ale
cable to control the unit with RS-232 co ands (see RS232 Co ands
Section Below).
4. CONTROL:
Connect to an active Ethernet link with an RJ45 ter inated cable to control
the unit with Web GUI (see Web GUI Control Section Below).
5. SERVICE:
Manufacturer use only.
6. DC 5V:
Connect the 5V DC power supply to the unit and plug the adaptor into an AC
outlet.
Remote Control
1. POWER:
Press this button to switch the unit ON or to
put it into standby ode.
2. OUTPUT A and 1~4:
Press buttons 1~4 to select the required
source for Output A.
3. OUTPUT B and 1~4:
Press buttons 1~4 to select the required
source for Output B.
4. OUTPUT C/D and 1~4:
Not applicable to this unit
RS-232
Protocol
Matrix Remote Control
   
   
   
    
   
! !
"  # " 
$  $ 
%  % 
&  & 
Baud Rate: 19,200bps Parity: None Flow Control: None
Data Bit: 8 bits Stop Bit: 1

RS-232 Commands
Command Description
' ()*+,-.-/'
0'0 ()*+,-.-0/'
0'0 Switch Output A B ... to 1~4 at the sa e
ti e
(1232(40132!53 Setting IP. SubNet. GateWay
<Static IP>
( IP configuration was reset to
factory default<DHCP>
,6! .78+*-*/9
: /),99
 /),
;'; ()*+77+/-.-/'
( Display the current atrix state and
fir ware version
( (8/<0
1'1 (1,1=(=>
? .78777@7*/A
Note:
RS-232 co ands will not execute unless followed by a carriage return.
Co ands are not case sensitive.

Web GUI Control
,B;./.+*/*A/+*)/+
</.)@@/)A8.+CAA/+
)@AA8@D+AA*@/@A(=
@8-+C+7.C*/A/-+A9-7E&"%:F+
@/))77A.78+C-<*//7A-.
7*/+C//7C@**/./)<.-B/-.-./<1
A9*/8

7*/+C(C@77/)-/+*/9-/+
8)779/@///9+*+8/9+
*+A+AA-A/**+5@!4*//7)77
7/A/@*+A/+)@AA8@
Note: +//91.7/@-A+/-7A@>/%
/@/-*/.@78)++5@!49-*/
Specifications
Video andwidth :@.B:!@.
Input Ports GD8.67F<G(=D=(-@
&=.F<G//7DH B;F<G4(0
D-9*--/78F
Output Ports GD8.67F
Output Resolution >!'54!<%:':%:.I
JGJKB B:L
HDMI I/O Cable Distance  K%=@<:K=@< KJGJ
Power Supply >B"D4(B14AA<1B6B4;
*9AF
ESD Protection -@/A8/A7E
M%>D=.A*+F
MJ>D*/*A*+F
Dimensions :D5FG$DFG%DF
Weight $"%
Chassis Material 7
Color 07*
Operating Temperature NOPQOROSNOPQOTOUVOPWOROXNSOPW
Storage Temperature YVNOPQOROZNOPQOTOYSOPWOROXSNOPW
Relative Humidity :'&:[D/=*/AF
Power Consumption 5

Connection Diagram