Converters.TV 840 User manual

Video to RGB Converter with
RGB by-pass switch ID# 840
Operation Man al

Introd ction
Video to RGB Converter with RGB by-pass switch allows Composite
video signals from NTSC or P L source to be converted into RGB H+V
(Combined Sync) or RGBsB (Sync On Green) to allow video to be viewed
on most CG 15kHz monitors.
Input a Composite Video signals from any source to the CV In of the
converter and output 15kHz (CG ) RGB Combined Sync (RGB H+V) or
RGsB Sync on Green (SoG) for connection to your 15kHz CG monitor.
t the same time, also have your 15kHz rcade Game board connected to
the converter using the specially designed VG 9 pin Twin Tail Cable
daptor.
The cable allows for your Game Board and Monitor to be connected to the
converter at all times. Use the toggle switch to select the RGB input or the
CV input.
Please note that this is a one way style conversion;
NTSC Video in = NTSC RGB (15k) Video out
P L Video in = P L RGB (15k) Video out
Feat res
• Digital decoding and encoding ensures best quality conversion.
• Converts NTSC/P L/SEC M Composite Video (CV) to RGB H+V
(combined sync) or RGsB(Sync on Green).
• Input System auto detecting.
• RGB video input pass through.
• Sync Polarity switchable between positive and negative(internal link).
• Output brightness adjustable.

Operating F nctions
and Controls
Front Panel
1. - And + b ttons/reset b tton- The – and + buttons are used to decrease
and increase the brightness level respectively. Simultaneously pressing the –
and + buttons returns brightness to its factory default value.
2. RGB H+V/RGsB switch- This button allows the user to select between
RGsB (Sync on Green) or RGB H+V(combined sync).
3. 9 Pin D Female connector:-
Pin No. Wire Colo r F nction
Pin 1 Grey GND
Pin 2 Brown Sync of source 1
Pin 3 Red Red out
Pin 4 Yellow Red in from source1
Pin 5 Green Green in from source1
Pin 6 Bl e Green out
Pin 7 P rple Blue out
Pin 8 Orange Blue in from source 1
Pin 9 Black Sync out
So rce 1: Loop through RGB/S input
So rce 2: Video Input
4. Toggle switch- Select between RGB Video input or CV Video input.

Rear Panel
1. DC power s pply inp t- This is the power supply input port.
2. Video inp t- This is the Composite Video input port.
Connection &
Installation
- Connect the RGB video source and monitor to the converter using the
special VG 9 Pin twin tail adapter cable.
(Connect wires as per VG 9 Pin connector configuration table)
- Connect the Composite Video source to the converter using a Composite
Video cable (yellow Plug).
- Set the switch to either RGB H+V or RGsB.
- Connect 12v DC Power supply and turn on.
- Use the - and + to adjust the level of brightness to the desired level.
Specifications
Inp t Video input- 1Vp-p 75 ohm RC Jack
RGB H+V input: Pass through
O tp t RGB: 0.7 Vp-p 75 ohm 9-pin D female connector.
Sync: 3 Vp-p positive or negative polarity
RGB H+V and RGsB
Power S pply DC 12V center positive
Dimensions 94mm (D) x 77mm (W) x 30mm (H)
Accessory VG 9 Pin Twin Tail adapter cable
User Manual.
Weight 0.4 Kg