Costco CAST TABLE User manual

Assembly Instructions
Caution : You must read this before you proceed.
CAST TABLE
CAUTION : This table is NOT a TOY.
Keep your child / children at bay in the process of assembly.
1 OF 5

No. Picture Description Qty
A
Table Top 1
BLegs Support Panels (Long) 2
CLegs Support Panels (Short) 2
J
Table Legs 4
No. Picture Description Qty
DBolts(M8*30mm）9
Washers ( 8mm ) 14
Springs Washers ( 8mm) 14
FBolts(M8*20mm）5
KSpanner 1
Before Beginning Assembly:
E
2 OF 5

Turn the table upside down on to a soft surface that does not scratch the table top.
Once turned upside down, you will be able to spot the Contact Points for the legs.
Attach four (04) Table Legs(J) to these Contact Points of Table Top(A) with Bolts(F), Spring
Washers and Washers(E) .
Do not over tighten, yet.
Step 1
Unpack and place all parts on a clean soft surface.
Note : It is recommended that you have a partner to assist in the assembly process.
Step 2
3 OF 5

Turn the table right side up.
Adjust the pre-installed Levellers at the end of each table leg until the table is level with the
ground.
Securely, tighten and fasten all the screws and washer-nuts.
Your table is now ready for use.
Step 3
NOTE : To HOLD the legs together in positon, the LONG and SHORT LEGS SUPPORT
PANELS WILL OVERLAP AT ALL 04 (four) CORNERs.
Proceed to affix the Long and Short Legs Support Panels (B&C) to the table legs with
Blots(D),Washers and Spring Washers(E).
Do not over tighten, yet.
Repeat the same process for all 08 (four) contact points of the Table Legs and the Legs
Support Panels.
Once all the panels are in place, go back to tighten the screw-bolts of the legs in step 2.
Tighten these bolts to the legs in a sequential direction.
By this, it allows the table legs to be locked into position evenly, thus reducing wobbles.
Thereafter, tighten up all screws in all the Leg Support Panels tightly into position.
{ Please note the direction of the table top pattern to the Leg Supports (B&C). }
Step 4
4 OF 5

5 OF 5