Crosswater US-BSW0101 User manual

Installation Instructions
Adjustable
wrench
Channel
locks
Plumbers’ putty
or caulking
Flat head
screwdriver
Cross head
screwdriver
Hexagonal
key
BASIN
DRAIN
Basin Drains
US-BSW0101 / US-BSW0103
Introduction
US-BSW0103 basin waste US-BSW0101 basin waste
Tools required
FOAM SEAL
WASTE FLANGE
RETAINING NUT
TAILPIECE
CLICKER PLUG
DRAIN BODY
RUBBER GASKET
FIBRE GASKET
BASIN
DRAIN
FOAM SEAL
WASTE FLANGE
RETAINING NUT
TAILPIECE
CLICKER PLUG
DRAIN BODY
RUBBER GASKET
FIBRE GASKET
This drain is designed for basin thickness ranges from1 ” to 1-3/4".
Please make sure the basin is the appropriate size as indicated.
NOTE:
US-BSW0101 - for basins without an overflow.
US-BSW0103 - for basins with an overflow.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.

Issue date: 15092019
Warranty - Due to the nature of drain usage, drains are excluded from the Crosswater London warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
www.crosswaterlondon.com
email: [e-mail]
8 Cleaning Instructions
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any overspray.
This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup. Follow instructions to
ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or disinfectants will
alter the surface finish.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass cleaners to
remain on the surface. Prolonged contact will alter surface finishes.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.