Crosswater Waldorf US-WF0613 User manual

Installation Instructions
Tape
measure
Safety
glasses
Hammer Flat head
screwdriver
1/4”
drill
Pencil Spirit
level
23-5/8"
11”
21-5/8"
10"
3-1/8"
Installation notes
The installation must comply with all plumbing codes including local
codes and be installed by a licensed plumbing contractor.
Assemble the parts on a mat to protect against scratching the surface.
Avoid getting cement, grit, sand or masonry products on to the surface.
Protect and cover the products during the installation period to
prevent damage from occurring.
IMPORTANT: Turn off the main water supply before connecting to
any existing pipework or doing any maintenance.
WARNING! Please check for any hidden pipes and cables, electric
or otherwise,before drilling holes in a wall or floor.
Introduction
All parts have been fully inspected throughout the production
process and only leaves our factory after a 15-stage QC process.
Carefully remove the items from the box and check that all parts have
been supplied.
Installation should be completed by at least two suitably competent
installers
Before beginning installation, please check for any damage that may
have occurred during transport. Note: Damage claims cannot be
made during or after installation.
Improper installation shall result in loss of warranty in case of
damage caused by impacts or rubbing against rough surfaces.
Wall fixings are not supplied. Source fixings which are suitable to the
site wall.
IMPORTANT: Please read these instructions carefully before
beginning and retain for future reference.
We do not accept responsibility for any problems that may occur
through incorrect installation.
Waldorf 23-5/8" Basin US-WF0613
Waldorf Pedestal Base US-WF0101
Dimensions
Tools required

36”
36” min
Underside
view of
xing hole
11/2”
1 Installation - pedestal
lInstall 2x6 backing behind the nished wall.
2 Installation - pedestal
lMark the center line on the
floor.
3 Installation - pedestal
lSet the basin on the pedestal and against the wall. Adjust the
pedestal if necessary.
lMark the two basin xing holes on the nished wall.
4 Installation - pedestal
lMove the basin and pedestal aside. Drill 1/4” holes at the
marked locations.
lInstall hanger bolts so they extend 1-1/2" beyond the finished
wall.

Underside
view of
xing hole
36”
36” min
33” +/-2”
5 Installation - pedestal 6 Installation - pedestal
lPosition the basin on the pedestal so the hanger bolts extend
through the fixing holes.
lLevel and secure the basin using cap nuts and washers.
DO NOT OVERTIGHTEN!
lApply sealant.
lFit overow cap.
1 Installation - wall
lInstall 2x6 backing behind the nished wall.
2 Installation - wall
lMark the horizontal center line on the
wall.

11”
11/2”
Underside
view of
xing holes
3 Installation - wall
lMark the two basin xing holes on the nished wall.
4 Installation - wall
lDrill ¼” holes at the marked locations.
lInstall hanger bolts so they extend 1½” beyond the finished
wall.
5 Installation - wall 6 Installation - wall
lPosition the basin on the hanger bolts through the fixing holes.
lLevel and secure the basin using cap nuts and washers.
DO NOT OVERTIGHTEN!
lApply sealant.
lFit overow cap.

Issue date: 05122019
Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
www.crosswaterlondon.com
email: [e-mail]
A simple routine of regular care will keep your fireclay products clean and fresh.
Rinse away any traces of soap and gently dry with a clean soft cloth after each use. A mild detergent, warm water and a soft cloth
will remove normal dirt and soap accumulations from surfaces. Soft abrasive cleaners may be used on vitreous china and fireclay.
Never use abrasive cleaners without water. Do not use caustic cleaners or disinfectants as they can alter the surface finish and void
the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and glass
cleaners to remain on the surface. Prolonged contact can alter surface finishes and void the warranty.
Cleaning Instructions