Crosswater US-SP380 User manual

Infinity Water Panels
US-SP380
US-SP500
Installation Instructions

Package Contents
x 2
x 4
x 1 x 1
x 1
x 1
Introduction
The water panel has been fully inspected throughout the production process and only leaves our factory
after a 15-step QC process.
Carefully remove the water panel from the box and check that all parts have been supplied.
Before beginning installation,check for any damage that may have occurred during transport.
Note: Damage claims cannot be made during or after installation.
Improper installation shall result in loss of warranty in case of damage caused by impacts or rubbing against
rough surfaces.
IMPORTANT: Please read these instructions carefully before beginning and retain for future
reference. We do not accept responsibility for any problems that may occur through incorrect
installation.
Installation notes
The installation must comply with all plumbing codes including local codes and be installed by a licensed
plumbing contractor. It is recommended that two people carry out the installation.
IMPORTANT! Before installing a new water panel it is essential that the supply lines are thoroughly flushed
in order to remove any remaining debris, solder or other impurities. Failure to carry out this simple
procedure can cause problems or damage to the function of the water panel.
Installing shut-off valves on incoming supply lines is recommended for ease of maintenance.
Turn off the main water supply before connecting to any existing pipe work or doing any
maintenance.
WARNING! Please check for any hidden pipes and cables, electric or otherwise,before drilling holes in
a wall, ceiling or floor.
2

US-SP380
US-SP500
3
MIN 14.5 psi
MAX 72.5 psi
BEST 43.5 psi
MAX 158° F/ 70° C
BEST 100°/104°F
38°/40° C
15"
2-1/2"
19-3/4"
2-1/2"
15"
19-3/4"
MIN 14.5 psi
MAX 72.5 psi
BEST 43.5 psi
MAX 158° F/ 70° C
BEST 100°/104°F
38°/40° C

PRODUCT
CODE
SP380
17-3/4’’
4
17-3/4’’ 3’’
22-1/2’’22-1/2’’ 3’’
SP500

24
19
6
7 8
4
5

Warranty - This Crosswater London product is covered by a limited lifetime warranty. For full details, terms and conditions please visit our website.
For further information contact:Crosswater London, 393 Fortune Blvd., Milford, MA 01757
Toll free number: 844-XWATER-1 (844-992-8371) tel: [phone] fax: [phone]
www.crosswaterlondon.com
email: [e-mail]
Issue date: 07262019
Cleaning Instructions
Rinse away any traces of soap and gently dry with a clean, soft cloth after each use. Rinse completely with water and dry any
overspray. This will maintain the finish and avoid water spotting.
To remove mineral deposits, use a 50/50 solution of white vinegar and water. Do not allow the solution to soak on the
product.
Simichrome Polish® contains a protective film to enhance maintenance and is helpful in preventing water spot buildup.
Follow instructions to ensure optimum results.
Never use an abrasive material such as a brush or scouring pad to clean the surface. The use of abrasive cleaners, cleansers or
disinfectants will alter the surface finish and void the warranty.
Do not allow certain materials such as toothpaste, cologne, shaving cream, nail polish remover, vinegar, wine, drain and
glass cleaners to remain on the surface. Prolonged contact will alter surface finishes and void the warranty.
We DO NOT recommend using any household cleaners as many can cause damage to the finish.
Please see the website for care instructions for specific finishes.