DANLERS CEPH NO Quick start guide

Installation notes
DANLERS Limited, Vincients Road, CHIPPENHAM, Wiltshire, SN14 6NQ, UK.
Telephone: [phone] Fax: [phone]
E-mail: [email protected] Web: www.danlers.co.uk
Company Registered Number 2570169 VAT Registration Number 543 5491 38
Products available from DANLERS
• PIRoccupancyswitches•Daylightlinkeddimmers•Manualhighfrequencydimmers
• Photocells • Radio remote controls • Time lag switches • Outdoor security switches
• Dimmers•Heating,ventilationandair-conditioningcontrols•Bespoke/O.E.M.products
Please call for more information or a free catalogue, or visit our website.
ThisproductconformstoBSEN60669-2-1.
Pleaseensurethemostrecenteditionoftheappropriatelocalwiringregulationsareobserved
andsuitableprotectionisprovidede.g.6ampsovercurrent,1kVovervoltage.Pleaseensure
thatthisdeviceisdisconnectedfromthesupplyifaninsulationtestismade.
Thisproductiscoveredbyawarrantywhichextendsto5yearsfromthedateofmanufacture.
Precautions and Warranty
Ceiling socket mounted photocell switches
CEPH NO CEPH RE
DANLERSceilingsocketmountingphotocellswitchescanbeplugged
into a Klik-AX lighting socket (DANLERS order codes: CESO or
CESOSQ(diagramA).
WhentheambientlightlevelfallsbelowtheLUXthresholdthephotocell
willswitchtheconnectedloadon.Itwillswitchthelightsoffagain
whenthelightlevelraisestoapproximatelytwicetheLUXthreshold,
toavoidthepossibilityof‘hunting’.
TheLUXthresholdcanbesetbytheusertobetweenapproximately
100and1000luxattheworksurfacebytheLUXadjuster(diagram
B).Thereisalsoaninniteluxsettingwherethelightswillbeswitched
on constantly.
There is a time delay of approximately a minute before switching
actuallyoccurs,toavoidnuisanceshorttermswitchingcausedbya
passing cloud etc. A small red LED changes state as soon as the LUX
thresholdistraversedtomakesetupeasier.
TheCEPHNOproductwillswitchthelightsonandoffwithoutuser
intervention.However with the CEPH RE, reset version, the load will
only switch on again once a manual wall switch (wired before the
photocell, diagram B) is switched off (for 5 seconds) and on again.
Eachtimethemanualwallswitch(wiredbeforeeithertypeofphotocell)
is switched, the lamp will switch on for 1 minute regardless of the
ambientluxlevel.
Loading
ThesePhotocellswitchescanswitchupto6amps(1500W)of:
• Fluorescentlamps,highfrequencyorswitchstart
• Incandescentormainshalogenlamps(recommendedwithintegralsafetyfuse)
• Electronicorwirewoundtransformers.
Theycanalsoswitchupto:
• 1amp(250W)offansormetalhalidelamps.
21/01/11 INS931 CEPH
Troubleshooting
The load will not switch on with the CEPH RE
• Themanualwallswitchmustbeturnedoffforabout5secondsand
back on again to reset the photocell.
The load switches on and off every minute with the CEPH NO
• Toomucharticiallightisenteringthephotocell.
The load switches off after a minute with the CEPH RE
• Toomucharticiallightisenteringthephotocell.
The lights switch on too early, when it is light enough in the room
• RotatetheLUXadjusterfurtherclockwise,towards‘-’.
The lights switch on too late, when it is already dark in the room
• RotatetheLUXadjusterfurtheranti-clockwise,towards‘+’.

Installation procedure
1.Pleasereadthesenotescarefullybeforecommencingwork.
Incaseofdoubtpleaseconsultaqualiedelectrician.
2.Makesurethepowerisisolatedfromthecircuit.
The Photocell should be plugged into a Klik-AX socket connected
asshownindiagramA:
L Livein
N Neutral in
A SwitchedLineout
3.DANLERSselltheKlik-AXsocketsunderthefollowingcodes:
 CESO: CircularKlik-AXsocketforBesabox
CESOSQ: SquareKlik-AXsocketforsinglegangbackbox
4.Switchonthesupplyandchecktheoperation.
Lux set-up
TheLUXisbestsetupwhenitisdarkoutsideandthelightsareon.
TodothisturntheLUXcontrolfullyclockwiseto‘-’thenslowlyanti-
clockwise(towards‘+’)untiltheredLEDturnson.
L N SL
CESO or
CESO SQ
L N
(A)
Back box or
BESA box
Lamp
load
CEPH NO or
CEPH RE
Manual wall switch:
Optional for CEPH NO,
for override off.
Compulsory for CEPH RE,
to reset the photocell.
LUX
max min
100
1000
A: Wiring diagram
B: Adjusting Lux