DELTACALOR Electro 1 User manual

ISTR_ELECTRO1 Rev. 17/04/2013
Manual
Use and Installation
TOWEL-HEATER WITH DIATHERMIC FLUID
ElEctro 1

2
60 cm
225 cm
300 cm
60 cm
60 cm
Volume
3Volume
2
Control
panel
Volume
1
PrEParing to install
Should damages be caused from breach of these regulations, the manufacturer’s guarantee shall be
invalidated.
Do not use the appliance outdoors.
- Your appliance is intended for domestic use. It may not be used for other purposes.
- If the appliance has been dropped, has been damaged or does not function correctly, do not use it and
ensure that the appliance power supply has been disconnected (fuse or switch).
- Do not dismantle the appliance. A poorly-repaired appliance can cause risks for the user. Contact your
retailer for any problem.
- If the power lead has been damaged, it must be replaced by the manufacturer, after-sales service or an-
other professional to avoid all danger.
- This appliance is not suitable for use by people (including children) with reduced physical, sensory or mental
capacities, or by people without specific experience and knowledge, without prejudice to their being able
to make use, through a person responsible for their safety, of monitoring or preliminary instructions on the
appliance use.
- Children should be monitored to ensure that they do not play with the appliance.
- Warning: In order to avoid any hazard to young children, it is recommended to install the unit so that the
lower radiant bar is at least 500 mm above the floor.
Before connecting the radiator, disconnect the power
supply using the general switch.
This radiator is a class II appliance. As such, it may
be installed in all rooms of the house, including in
protection volumes 2 and 3 of a bathroom.
The heating appliance must be installed in such a
way that the switches and other control devices can-
not be touched by someone in the bath or shower
(in compliance with standard NF C15-100). The ra-
diator must not be installed beneath a socket. The
radiator must be installed at least 15 cm away from
all obstacles (shelves, curtains, furniture, etc.). The
power circuit of this appliance must include an all-
pole circuit breaking device (in compliance with
standard NF C15-100).
safEty instructions
THESE INSTRUCTIONS MUST BE READ CAREFULLY TO ENSURE THE PRODUCT OPERATES SAFELY.
WE WOULD THEREFORE STRONGLY RECOMMEND READING THEM BEFORE STARTING ON
INSTALLATION AND KEEP THEM FOR FUTURE REFERENCE. CALL A QUALIFIED TECHNICIAN FOR
HELP IF YOU HAVE ANY DOUBTS ABOUT INSTALLING THE PRODUCT.

3
H
A
L
L1
NO
Pow E r s u P P ly and
ElEctrical connEctions
The power supply connection must be performed
by a qualified professional technician.
In accordance with the rules in force, the power of
the towel heater must be protected by an RCD of 30
mA and an overcurrent protection device, suitable to
the characteristics of the connection line.
Before using the appliance the first time, check that
the voltage used corresponds to that specified on
the appliance.
This radiator is a class II appliance (double electrical
insulation).
Earth connection is prohibited.
Connection of the three wires must take place in an
electrical junction box compliant with current regula-
tions.
Install the socket for the electrical connection with
plug inside the volume 3.
The pilot wire must be disconnected if not in use.
Single-phase power supply 230 V~ ±10% 50Hz:
- Blue wire: Neutral
- Brown wire: Live
- Black wire: Pilot Wire
fixing thE tow E l hEatEr
Important: Observe a mini-
mum of 150 mm between the
bottom of the towel heater and
the floor.
Models (*) A H L L1
BAE069050 EB/ES 777 mm 517 mm 360 mm 250 mm
BAE092050 EB/ES/EC 795 mm 738 mm 360 mm 250 mm
BAE120050 EB/ES/EC 713 mm 990 mm 360 mm 250 mm
BAE180050 EB/ES/EC 713 mm 1554 mm 360 mm 250 mm
(*) EB = RAL 9010
ES = Colors
EC = Chrome

4
dEscriPtion o f fixturEs
3 × 3 × 3 × 3 × 3 × 3 × 3 × 3 ×
Ø 10
A
A
1 2
3NOTE: The pins and the screws do not come with the
package.

5
rangE and dimEnsions
Width
Depth
Height with thermostat
Models (*) Power Height with
thermostat Width Depth Number of tubes
Number of towel-
holder slots
BAE069050 EB/ES 300 W 736 mm 500 mm 80 mm 12 2
BAE092050 EC 300 W 958 mm 500 mm 80 mm 18 2
BAE092050 EB/ES 500 W 958 mm 500 mm 80 mm 18 2
BAE120050 EC 500 W 1217 mm 500 mm 80 mm 27 2
BAE120050 EB/ES 750 W 1217 mm 500 mm 80 mm 27 2
BAE180050 EC 750 W 1846 mm 500 mm 80 mm 40 2
BAE180050 EB/ES 1000 W 1846 mm 500 mm 80 mm 40 4
(*) EB = RAL 9010
ES = Colors
EC = Chrome

6
tEchnical sPEcifications
Declaration of conformity: We hereby declare, under our own responsi-
bility, that the products presented in these instructions comply with all
basic requirements of the Low Voltage Directives 2006/95/EC and EMC
2004/108/EC and RoHS 2002/95/EC.
Manufacturer: DELTACALOR
The symbol , on the product indicates the obligation to dispose of it, at the end of its working life, with a
specialised collection centre, in compliance with Directive WEEE 2002/96/EC. Should you choose to replace
it, you may return the old appliance to the distributor. This product is not ordinary household waste. By dispos-
ing of the product appropriately at the end of its working life, we can protect the environment and limit use
of its natural resources.
Power supply: 230V ±10% 50Hz CA
Safety standards:
- EN60335-1
- EN60335-2-30
- EN60335-2-43
Environment:
- Class II, IP 64.
- Storage temperature: between -10°C and +50°C.

7

DELTACALOR s.r.l.
Via Mazzini
23801 – Calolziocorte – Lecco
Italy
www.deltacalor.com