Drive 10215RD-1 User manual

lifetime limited
warranty
Your Drive brand product is warranted to be free
of defects in materials and workmanship for the
lifetime of the original consumer purchaser.
This device was built to exacting standards
and carefully inspected prior to shipment. This
Lifetime Limited Warranty is an expression of our
confidence in the materials and workmanship of
our products and our assurance to the consumer
of years of dependable service.
In the event of a defect covered by this
warranty, we will, at our option, repair or replace
the device.
This warranty does not cover device failure
due to owner misuse or negligence, or normal
wear and tear. The warranty does not extend to
non-durable components, such as rubber
accessories, casters, and grips, which are subject
to normal wear and need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
© 2006 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
Item # 10215RD-1
Shown
WE I I S
go-lite
oversized rollator
www.drivemedical.com
EU Authorized Representative
Drive Medical
Ainsley’s Industrial Estate,
Elland HX5 9JP
5

Always engage and disengage wheel locks on both
sides simultaneously.
1. To Slow Down or Come to a Temporary Stop
— Pull up slowly on the loop locks with four
fingers until unit slows down or comes to a
temporary stop.
2. To Temporarily Lock Wheels in Position — Press
down on both loop locks with palms until you
hear a “click” that will tell you wheels are locked.
3. To Release Wheel Locks — Push up on both loop
locks with palms of hand to original position.
assembly instructions
CAUTION Do not aempt to adjust or operate
Rollator without carefully reading all instructions
in this manual.
1. First remove all contents from carton: backrest,
handle with tube, Rollator frame and Basket.
2. Open frame and slide padded backrest into
frame brackets making sure snap booms
protrude through holes.
3. Unscrew tightening knob from handle and insert
handle tube into frame at desired height lining
up holes appropriately. Slide bolts through holes
from the inside and screw on tightening knob
until secure.
1. Please make sure the Rollator is fully opened,
seat is down and the folding bar under seat is
locked in the down position.
2. Be sure that both knobs are fully tightened and
are at equal heights. Test Rollator for stability
before applying full weight to hand grips.
3. Test the loop locks before operating the
Rollator. When wheels are locked (see
illustrations for locking and releasing locks
below), lock bar on rear wheels should prevent
wheels from turning. If the wheels turn while
brakes are locked, please take unit back to
dealer for adjustment. When locks are released,
the wheels should turn freely.
4. Always lock loop locks before siing and do not
use seat when unit is on an incline or
uneven ground.
5. Replace tires when significantly worn or
damaged.
6. Do not have anyone push you while you are
seated on the Rollator. This is a walking aid only
and is not to be used as a transportation device.
safety precautions loop lock operation
Orthodic
Hand Grips
Loop Locks —
Safest System
Available
Height
Adjustable
Wide
Comfortable
Seat
Folding Hinge
for Portability
Sealed Wheel
Bearing for Smooth
Operation
Hanging Basket
for Functionality
& Storage
Backrest