Drive 11130-2 User manual

Your Drive branded product is warrantied to be
free of defects in materials and workmanship for
the lifetime of the product for the original con-
sumer purchaser.
This device was built to exacting standards and
carefully inspected prior to shipment. This Lifetime
Limited Warranty is an expression of our confi-
dence in the materials and workmanship of our
products and our assurance to the consumer of
years of dependable service.
This warranty does not cover device failure due to
owner misuse or negligence, or normal wear and
tear. The warranty does not extend to non-durable
components, such as rubber accessories, casters,
and grips, which are subject to normal wear and
need periodic replacement.
If you have a question about your Drive device or
this warranty, please contact an authorized Drive
dealer.
deluxe bariatric commode
item #11130-2
lifetime limited
warranty
© 2014 Medical Depot, Inc. All rights reserved.
Drive is a trademark of Medical Depot, Inc.
Port Washington N.Y. 11050 USA Made in China
Rev.2.05.07.14

commode assembly
instructions and
precautions
bucket
slides in
Before assembling seat, allow toilet seat to reach
room temperature if exposed to cold. This will help
prevent the seat and lid clamps from cracking while
being assembled.
Seat is easily removed by lifting it off commode frame.
Install commode bucket by sliding the bucket into
receptacle located under the seat from the front of
the commode.
1
2
3
Before use, adjust height of each leg to your spe-
cific needs, making sure all legs are at the same
height. When desired height is reached, lock legs
into place by aligning buttons into proper holes,
per illustration above.
To be sure legs are locked into place by pushing
down on or by pulling legs.
1
2
Toilet seat must be in down position before use.
Failure to do so may result in breakage of commode
and possible injury.
Do NOT install commode without first reading and
understanding this assembly and instruction sheet.
If you can not understand these instructions, con-
tact a healthcare, dealer or technical professional
before attempting to install. Otherwise, injury or
damage may occur.
Inspect all parts for shipping damage before assem-
bly. If there is shipping damage - DO NOT USE.
Contact dealer/carrier for further instructions.
Make certain that the height adjusting snap buttons
fully protrude through the same respective hole of
each leg extension. This will ensure that the leg
extensions are securely locked in position and an
even height is achieved (see Figure 1).
Ensure ALL screws, nuts and/or bolts are tightened.
Check the rubber tips on the leg extensions for rips,
wear or if they are are missing. Immediately replace
any or all if any of these imperfections exist.
All four leg extensions with rubber tips MUST touch
the floor simultaneously at all times.
Users with limited physical strength should be super-
vised or assisted while using commode.
1
2
3
4
5
6
7
8
removable
seat
back
support
adjusting leg height
assembling commode
Item # 11130-2 Shown
For use with all
Deluxe Bariatric Commode
WEIGHTCAPACITYLBS
additional precautions
Rev.2.05.07.14