DSC PG4975 Manual

Date: February 8, 2017
To: Global Distributors and Dealers
PGx975 PowerG Wireless
Vanishing Door/Window
Contact
Overview
It has come to our attention that due to improper re-assembly of the plastic portion of the
PGx975 PowerG Wireless Vanishing Door/Window Contact, there is a possibility that the
tamper switch of the device could become damaged, to the point where it may not properly
detect a tamper condition when the case is opened, or constantly show a tamper condition
even when the device is assembled.
Re-Assembly Instructions
To ensure that the PGx975 plastic is properly re-assembled at the time of installation or when
the battery is replaced, please follow the instructions below. The re-assembely instructions
will also be updated in the Installation Manual.
To close the cover, complete the following steps (also seen in the image below)
1. Insert the two teeth on the front cover into the corresponding slots on the base.
2. When the cover is at a 30-degree angle to the base, push it into place until you hear a
click.

Affected Part Numbers
Model
Description
PG4975
PowerG 433MHz Wireless Vanishing Contact
PG8975
PowerG 868MHz Wireless Vanishing Contact
PG9975
PowerG 915MHz Wireless Vanishing Contact
Order Entry Contact
Sales Contact
Technical Support Contact
1-888-888-7838
For additional
information please
contact your local sales
representative or
email [email protected]
North America: [phone]
Latin America: [phone]
EMEA & AsiaPac: Toll Free 800-
22558926