Dynojet Power Commander III USB User manual

2001-2005 Honda CBR600 F4i - PCIII USB - 1i108-411
2001-2005 Honda CBR600 F4i
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Parts List
1Power Commander
1USB Cable
1CD-ROM
1Installation Guide
1Power Adapter
2Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port

1Remove the main seat and the
passenger seat.
2Remove the black left hand inner fair-
ing panel by removing the two bolts
(this panel surrounds the gauges down
to the fuel tank).
3Unplug the connector (Fig. A) which
may be located under the rubber flap.
NOTE: There is another connector located
under the fuel tank near the rear
shock. DO NOT plug the PCIII con-
nectors into this area.
4Plug the connectors from the PCIII in-
line of the stock wiring harness
(Fig. B).
5Route the PCIII wiring along the
inside of the frame towards the bat-
tery.
NOTE: The fuel tank may have to be lifted up
to do this.
6Locate the negative side of the battery
by lifting up the ECU and removing
the pins that holds the battery cover
down (Fig. C).
Fig. AFig. B
Fig. C
i108-411 www.powercommander.com 2001-2005 Honda CBR600 F4i - PCIII USB - 2
Unplug this connector
Pull up these pins to
access the battery
Stock connectors
PCIII connectors

7Connect the ground wire from the
PCIII to the negative side of the bat-
tery (Fig. D).
8Reinstall the battery cover and ECU.
9Install the PCIII in the rear section of
the trunk using the supplied velcro
(Fig. E). Make sure to clean both sur-
faces first with alcohol.
10 Reinstall the bodywork.
11 Reinstall the main seat and the pas-
senger seat.
Fig. DFig. E
i108-411 www.powercommander.com 2001-2005 Honda CBR600 F4i - PCIII USB - 3
Ground wire from PCIII