Dynojet power commander III User manual

i206-411 2002-2003 Kawasaki ZX-12R - PCIII USB - 1
2002-2003 Kawasaki ZX-12R
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89031 [phone] www.powercommander.com
Parts List
1 Power Commander
1 USB Cable
1 CD-ROM
1 Installation Guide
1 Power Adapter
2 Power Commander Decals
2 Dynojet Decals
1 Velcro®Strip
1 Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
Expansion Port USB Port

1) Remove the passenger seat or solo
seat cover section.
2) Remove the main seat.
3) Remove the fuel tank shell and prop
the front of the fuel tank up.
4) Disconnect the fuel injector connector
shown in Fig. A. This connector is
located on the backside of the frame
towards the bottom of the fuel tank.
There are two connectors side by side,
disconnect the one on the left.
5) Plug the connectors from the Power
Commander in line of these connec-
tors. (Fig. B)
6) Disconnect the rear brake light con-
nector. (Fig. C)
Fig. AFig. B
Fig. C
2002-2003 Kawasaki ZX-12R - PCIII USB - 2i206-411 www.powercommander.com
Separate this
connector
Locate wire and connector
from rear brake light switch
Connectors from
Power Commander
Stock connectors

7) Plug the connectors from the Power
Commander in line of these connec-
tors. (Fig. D).
8) Connect the ground wire from the
Power Commander to the negative
side of the battery (Fig. E).
9) Mount the Power Commander in the
rear trunk area using the supplied vel-
cro strips.
10) Reinstall the fuel tank and its shell.
11) Reinstall main seat and passenger
seat/solo cover.
Fig. DFig. E
2002-2003 Kawasaki ZX-12R - PCIII USB - 3i206-411 www.powercommander.com
Ground wire from
PCIIIUSB
Plug the main power wire from
the Power Commander into the
rear brake light connectors