Dynojet Power Commander III USB EX User manual

i132-411EX 2008 Honda CBR1000RR - PCIII USB EX - 1
2008 HONDA
CBR1000RR
INSTALLATION INSTRUCTIONS
Dynojet Research • 2191 Mendenhall Drive • North Las Vegas, NV 89081 • [phone]
DOWNLOAD THE POWER COMMANDER SOFTWARE AND LATEST MAPS FROM OUR WEBSITE:
WWW.POWERCOMMANDER.COM
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
PARTS LIST
quantity description
1 power commander EX
1USBcable
1cd-rom
1 installation guide
1poweradapter
2 power commander decal
2dynojetdecal
2velcrostrip
1 alcohol swab USB port
expansion port

i132-411EX
2008 Honda CBR1000RR - PCIII USB EX - 2
The ignition must be turned OFF before
installation.
1 Remove the main seat and the passenger seat.
2 Remove the fuel tank cover.
3 Lift the fuel tank up or remove.
4 Unbolt the air box from the throttle bodies.
The air box does not need to be totally
removed to install the PCIII USB EX.
5 Using the supplied velcro, secure the
PCIII USB EX in the tail section as shown in
Figure A. Make sure to clean both surfaces with
the alcohol swab before attaching.
6 Route the PCIII USB EX harness down the left
side of the bike.
7 Unplug the stock wiring harness from each of
the lower injectors as shown in Figure B.
The lower injectors are located on the throttle
bodies.
8 Attach the connectors from the PCIII USB EX to
the stock injectors and stock connectors as
shown in Figure C.
Figure AFigure BFigure C
unplug stock
wiring harness

i132-411EX
2008 Honda CBR1000RR - PCIII USB EX - 3
9 Located the Throttle Position Sensor (TPS)
connector.
With the air box moved out of the way, you can
access the TPS.
10 Unplug the TPS connector from the right hand
side of the throttle body as shown in Figure D.
11 Attach the connector from the PCIII USB EX to
the stock TPS and wiring harness as shown in
Figure E.
12 Attach the ground wire from the PCIII USB EX
to the negative side of the battery as shown in
Figure F.
13 Reinstall the air box and fuel tank. Verify the
tank does not pinch the PCIII USB EX wiring
harness.
14 Replace the seats.
15 Insert the cd provided into your computer’s
cd-rom drive.
16 Follow the on-screen instructions to install the
PCIII USB software.
Visit www.powercommander.com to download
software tutorials and the latest maps.
Figure DFigure EFigure F
unplug TPS
connector
PCIII USB EX
connectors
stock
connector
ground wire from
PCIII USB EX