Dynojet Power Commander III USB User manual

i233-411www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 1
2008 Kawasaki ZX10R
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com
Parts List
1Power Commander
1USB Cable
1CD-ROM
1Installation Guide
1Power Adapter
2Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB Port
Expansion Port

1. Remove the main seat and the
passenger seat
2Remove the right hand side tail sec-
tion (Fig. A).
3 Prop the front of the fuel tank up.
4Remove the pins on the underside tail
section (Fig. B).
5Route the PCIII harness between the
underside tail section and subframe
(Fig. C).
Continue routing the harness down
the right hand side of the bike towards
the throttle bodies.
Fig. AFig. B
Fig. C
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 2
Remove covers
Remove pins
PCIII harness

6Unplug the main wiring harness from
the throttle bodies (Fig. D).
This is a 16 pin BROWN connector
located under the fuel tank on the
right hand side of the bike
7Plug the PCIII connectors in-line of
the stock wiring harness and throttle
body harness (Fig. E).
Fig. DFig. E
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 3
PCIII connectors
Stock connectors
Unplug connector
8Attach the ground wire of the PCIII
to the negative side of the battery
(Fig. F).
Fig. F
PCIII ground wire

9Using the supplied velcro attach the
PCIII to the inner part of the right
hand fairing (Fig. G).
Use the alcohol swab to clean both
surfaces before attaching.
10 Reinstall all bodywork and fuel tank.
Fig. G
i233-411 www.powercommander.com 2008 Kawasaki ZX10R - PCIII USB - 4