Dynojet Power Commander III USB User manual

i921-411 www.powercommander.com 2005-2006 Victory Hammer - PCIII USB - 1
2005-2006 Victory Hammer
Installation Instructions
Dynojet Research 2191 Mendenhall Drive North Las Vegas, NV 89081 [phone] www.powercommander.com
Parts List
1Power Commander
1USB Cable
1CD-ROM
1Installation Guide
1Power Adapter
2Power Commander Decals
2 Dynojet Decals
2 Velcro®Strip
1Alcohol Swab
You can also download the Power
Commander software and latest maps
from our web site at:
www.powercommander.com
The ignition MUST be turned
OFF before installation!
PLEASE READ ALL DIRECTIONS BEFORE STARTING INSTALLATION
Button Adjustment Display
Faceplate Buttons
USB Port
Expansion Port

1 Remove the left hand side cover.
2Remove the battery.
3Remove the three bolts that hold
the battery tray to frame and pull
the battery tray out (Fig. A).
4Unplug the stock wiring harness
from the ECU, which is attached
to the back of the battery tray
(Fig. B).
5Install the Power Commander to
the inner rear fender. Make sure
the Power Commander is as far
to the right hand side of the bike
as possible (Fig. C).
Make sure to clean the inner
fender with the supplied alcohol
swab first.
Use the supplied velcro to attach
the Power Commander to the
inner rear fender.
Fig. AFig. B
Fig. C
i921-411 www.powercommander.com 2005-2006 Victory Hammer - PCIII USB - 2
Remove these bolts
Unplug this connector
ECU

6Plug the connectors from the
Power Commander in-line of the
ECU and stock wiring harness
(Fig. D).
7Reinstall the battery tray and
battery.
8Reinstall the side cover.
9Make sure all wires will not get
pinched or damaged.
Fig. DFig. E
i921-411 www.powercommander.com 2005-2006 Victory Hammer - PCIII USB - 3
PCIII connectors
Stock connector
Top view of install
ECU