EAST COAST Monaco Wardrobe User manual

Monaco
Wardrobe

2
Hardware
Please read the instructions and warnings carefully before use to ensure safe and satisfactory operation
of this product.
Your child’s safety is your responsibility. If you have a query with this product or require replacement
parts, please contact 01692 408802.
Lay out the parts on a soft level surface and compare to the part/fixing checklist on pages 2 and 3. Do
not discard any packaging until you are sure that you have all the parts.
Keep children clear during assembly as pack contains small parts which may present a choking hazard.
You will need the following tools to complete assembly:
Cross-point screwdriver. Flat-Bladed screwdriver.
Important
Retain for future reference: Read carefully
B x 10
C x 32
D x 30
Ø 8mm
A x 18
(45mm)
J x 4
L x 6
I x 10
(38mm)
K x 2
G x 6
(25mm)
H x 36
(15mm)
F x 32
E x 4
Ø 10mm
M x 6
O x 2
(10mm)
Hexagon Key x 1
N x 2
(10mm)
P x 4
(15mm)

3
Wooden Parts
Centre Front Crossbar
Clothes Rail x 2
Upper Rear Crossbar
Panel Joining Strip
Door Block
Wardrobe Side x 2 (L & R)
Rear Frame Side x 2 (L & R)
Door x 2 (L & R)
Foot x 4
Top Panel
Drawer Back
Drawer Base
Shelf
Drawer Front
Drawer Side x 2 (L & R)
Lower Frame
Front Frame Side X 2 (L & R)
Lower Front Crossbar
Back Panel x2
Lower Rear Crossbar
Upper Front Crossbar

4
Assembly 1
Assembly 2
Assembly 3
A x 4
Lower Frame
Foot
Foot
Foot
Foot
E x 4
D x 2
D x 2
Upper Rear Crossbar
Lower Rear Crossbar

5
Upper Rear Crossbar
Back Panel
NOTE: Rounded corner
Assembly 4
Assembly 5
Lower Rear Crossbar
B
A
Rear Frame Side
Rear Frame Side
Back Panel
Panel Joining Strip
B
A

6
F x 7
F x 5
Wardrobe Side
Assembly 6
Assembly 7
Shelf
D x 2
D x 2
F x 2
Assembly 8
NOTE:
Repeat for second Wardrobe Side.
D x 6

7
Wardrobe Side
A x 2
Lower Frame
NOTE:
Cutout opposite to
hinge blocks
Hinge block
Assembly 9
Shelf
Assembly 10
C x 2

8
Assembly 12
Assembly 11
Assembly 13
A x 2
Wardrobe Side
F x 2
F x 2
G x 2
Door Block
Top Panel
C x 2
C x 4
Top Panel
D x 4

9
Assembly 14
Assembly 15
D x 3
D x 3
Upper Front Crossbar
Centre Front Crossbar
Lower Front Crossbar
I x 3
C x 6
C x 6

10
Assembly 16
Assembly 17
Front Frame Side
Upper Front Crossbar
Centre Front Crossbar
Lower Front Crossbar
Front Frame Side
A
B
F x 12

11
Assembly 18
Assembly 19
Front Frame
(from Assembly 17)
I x 3
C x 12
Drawer Front
Drawer Side
Drawer Base
Drawer Side
G x 2
G x 2

12
Assembly 20
Assembly 21
NOTE: Ensure that inner drawer runner
is at forward edge before inserting the drawer. Position
the drawer mounted strip inside the inner runner and
holding the drawer level, gently slide the drawer all the
way into the frame.
To open the drawer, push lightly on the pad on the
drawer front and allow the drawer to slide out a little,
then pull the rest of the way open.
To remove the drawer, locate the
plastic tabs on the drawer mounted
strips. Press gently down on one side
and lift the other whilst pulling the
drawer out.
Drawer Back
Clothes Rail
Clothes Rail
Drawer
I x 2
I x 2
J x 4

13
Assembly 22
Assembly 23
NOTE:
Orientation of part K.
M x 6
H x 4
Per part M
(24 total)
P x 4
1.
2.
K

14
Screw 1
Screw 2
NOTE:
To adjust the fit of the doors in the frame,
position the wardrobe where it will be
used and use screws 1 and 2:
Screw 1 loosens the hinge to move the
door forward or backward.
Screw 2 moves the door closer to, or
further from the frame.
To open and close doors and drawer,
press firmly on the pad(s) and release.
2.
Assembly 24
Assembly 25
1.
Door
O
N
H x 2
(6 total)
NOTE:
Repeat for second Door.
Screw 1
Screw 2
Pad
Pad

15
Assembly 26
The wardrobe is supplied with a fixing kit which will secure it and help to guard against accidental tipping.
WARNING : Installation only to be carried out by a competent person.
Check the suitability of the wall before fitting.
1. Place the wardrobe against the wall where it is to be fitted. Mark the wall at the centre of the top edge of the
wardrobe. Move the wardrobe away.
2. Using the 25mm screw, washer and the appropriate wall fixing, attach the fabric strap to the marked position.
3. Re-position the wardrobe. Attach the strap to the top of the wardrobe using the 15mm screw and the washer.
Before use, ensure that the strap is securely fixed to both the wall and the wardrobe.
Washer x 2
Screw (15mm)
Screw (25mm)
Plastic wall plug
(for brick and masonry wall use only)
Fabric strap
1
2
3
The type of wall fixing you will require depends on the construction of the wall. See below for details. If in doubt,
seek professional advice:
Wood: If fixing to wood make
sure that it isn’t chipboard as
screws can easily pull away
the core structure.
Brick or masonry: Use the
wall plug, provided you are
sure that your wall is sound.
Cavity wall: Special toggle
wall plugs needed.
Seek expert advice.

Customer Care line for this Product 01692 408802
7849-01
East Coast Nursery Ltd. Robertson House, North Walsham, Norfolk, NR28 0BX
www.eastcoastnursery.co.uk
Care & Maintenance
Your furniture may be cleaned by wiping with a damp cloth and drying with a soft clean cloth.
Do not use abrasives, bleach, alcohol or ammonia-based household polishes.
Take care when handling or moving the furniture. Careless handling may cause damage.
Regularly check that all fixings are tightened and that there are no broken or damaged parts.
In use
All assembly fixings should always be tightened properly.
Be aware of the risks of open fires and other such sources of strong heat, such as electric bar fires, gas
fires, etc. in the near vicinity of the wardrobe.
Do not use if any of the parts are broken, torn or missing.
Any additional or replacement parts can only be obtained from the manufacturer or the distributor.
Only use the wardrobe on a stable and level surface.
Ensure that the wall strap is used to securely attach the wardrobe to the wall to prevent tipping.