EasyStand Evolv User manual

Evolv Perfect Fit Guide
®
step one - meas re
Before transferring into the Evolv, measure
for approximate (A) seat depth and seat to
(B) foot plate settings.
Caution: These ad ustments are only to be
made while the unit is unoccupied.
step two - seat depth
Use the above measurement (A) to ad ust
the seat depth on the stander, measure
from the front of the seat to the back. To
ad ust the seat depth, loosen the knob
under the seat (C). Depress the snap
button on the ad ustment tube while
moving the back (D). Ad ust the seat depth
until the proper measurement has been
reached. Tighten the knob (C) after
ad usting.
Caution: The following ad ustments are only
to be made in the seated position.
step three - back angle
After achieving the desired seat depth,
rotate the back angle (E) ad ustment knob
so the (F) seat/back angle indicator is in
the green area prior to standing.
Note: Repeat steps 2 and 3 for each color
adjustment.
step fo r - foot plates
Use the (B) measurement to ad ust the
foot plate height. Loosen the (G) ratchet
handles on the foot plates to ad ust height
and plantar/dorsi. Tighten ratchet handles
after positioning. The knees should be
slightly lower than the hip (H).
step five - positioning
Position the user’s hips as close as
possible to (I) Evolv’s hip pivot. To
determine correct positioning, only two
fingers should fit between the front of the
seat and the back of the knee (J).
step six - knee pad
Ad ust the (K) knee pad so it fits
comfortably up to the knees.
(C) (D)
(B)
(A)
(F) (E)
s t nd.com 800• 42•8968
Inspect your standing frame periodically to
ensure it is in safe operating condition.
!
(G) (H)
(K)
(I) (J)
Glider Perfect
Fit G ide
!

Glider Perfect Fit Guide
Glider
step one - meas re
Before transferring into the Glider,
measure for approximate (A) seat depth
and seat to (B) foot plate settings.
Caution: These ad ustments are only to be
made while the unit is unoccupied.
step two - seat depth
To ad ust seat depth, loosen the knob
under the seat (C). Use measurement (A)
and measure from the inside of the knee
pad to the back. Depress the snap button
on the ad ustment tube while moving the
back (D). Ad ust the seat depth until the
proper measurement has been reached.
Tighten the knob (C) after ad usting.
Caution: The following ad ustments are only
to be made in the seated position.
step three - back angle
After achieving the desired seat depth,
rotate the back angle (E) ad ustment knob
so the (F) seat/back angle indicator on the
side of the unit is in the green area prior
to standing.
Note: Repeat steps 2 and 3 for each color
adjustment.
step fo r - foot plates
Use the (B) measurement to ad ust the
foot plate height. Loosen the (G) knobs on
the foot plates to ad ust height. Tighten
the knobs after positioning. The knees
should be slightly lower than the hip (H).
step five - positioning
Position the user’s hips as close as
possible to (I) Glider’s hip pivot.
step six - knee pad
Slide into knee pads (J) and secure the calf
straps behind the knees.
(C) (D)
(B)
(A)
(F) (E)
Inspect your standing frame periodically to ensure it is in safe operating condition.
(G) (H)
(I) (J)
Evolv Perfect
Fit G ide
!
!