Eaton Power Xpert Gateway 900 Instruction Manual

6 (152.4)
Front View 4.5 (114.3)
Side View
2 (50.8)
5.625 (142.875)
1.625 (41.275)
5.04 (128)
2.56 (65)
Top View
6 (152.4)
Front View
Remove and then reattach these
screws to rotate for vertical mounting
1.97
(50)
2.023
(51.402)
0.556
(14.12)
Side View
Gnd +V
Gnd +V
24
VDC
Supply
Gnd +V
Power Xpert Gateway
Power Xpert Gateway
Installing the Power Xpert Gateway 900
1Mounting
2Wiring
1. Connect the two power supply leads from
a 24 VDC, class 2 power supply to the
two-pin Phoenix connector shipped with
the unit.
2. Insert the connector into the power
socket marked 24VDC. The power LED
(above the power socket) will light.
Power Xpert Insight™
Gateway
COM 1COM 2
USB to PC
3Connecting
You can connect a PXG 900 to a PC via the USB A to USB Mini-B cable shipped with the gateway. You’ll
need a USB driver for your PC to connect with the PXIG. You can download this and the product docu-
mentation from http://eaton.com/PXG. To connect to the PXG 900 via the USB cable:
1. Open a browser and navigate to: http://192.168.200.101.
2. The default user name and password is admin.
3. The Help menu leads to the user guides.
Eaton Corporation
877-ETN-CARE (877-386-2273)
Eaton.com/pxg
© 2014 Eaton Corporation
All Rights Reserved
Printed in USA
June, 2014
MN152004EN
Panel Mounting
DIN Rail Mounting
Grounding
See reverse side for important
safety and warning statements.

WARNING
Indicates a hazardous situation, which, if not avoided, could result in death or serious injury.
CAUTION
Indicates a hazardous situation, which, if not avoided, could result in minor or moderate injury.
NOTICE
Indicates a situation which can cause damage to the unit, personal property and/or the environment or cause the
equipment to operate improperly.
WARNING
The safety message that follows has WARNING level hazards.
SHOCK HAZARDS!
Follow all Warnings and Cautions. Completely read and understand the information in this document before attempting
to install or operate the equipment. Only qualied personnel are to service any Power Xpert device.
INSTALLATION AND TROUBLESHOOTING PROCEDURES MAY REQUIRE PROXIMITY TO EXPOSED ENERGIZED (LIVE) ELECTRI-
CAL WIRING AND/OR PARTS WHERE THE HAZARD OF FATAL ELECTRIC SHOCK IS PRESENT.
Properly ground the PXG900 during installation.
CAUTION
THE PXG900 CONTAINS A LITHIUM BATTERY. THERE IS A RISK OF EXPLOSION IF THE BATTERY IS REPLACED BY AN INCOR-
RECT TYPE.
CHECK YOUR LOCAL AND STATE REGULATIONS FOR PROPER DISPOSAL OF LITHIUM BATTERIES.