Electrolux Professional 351156 Instruction manual

GENERAL INSTRUCTIONS
Before installing and starting the
appliance, carefully read this
handbook as it provides important
information and instructions on safe
installation, use and maintenance.
Carefully keep this handbook for
further consultation by the various operators, or in
case the appliance is resold.
ATTENTION!
Appliance installation and any adaptation or
maintenance work must only be carried out by
professionally qualified personnel authorised by
the Manufacturer.
This appliance is intended for specific industrial use;
any other use is deemed improper.
It must only be used by trained personnel.
Always switch the appliance off in case of a fault or
poor operation.
For any repairs, only turn to a service centre
authorised by the manufacturer and demand
original replacement parts.
Failure to observe the above can compromise
appliance safety and invalidates any form of
warranty.
Do not wash the appliance with direct jets of water.
Do not use products containing chlorine (sodium
hypochlorite, hydrochloric acid, etc.),
even if diluted,to clean the steel.
The manufacturer declines any
liability for operations carried out
on the appliance without following
the instructions given in this
manual.
No part of this manual may be reproduced.
INSTALLATION INSTRUCTIONS
ATTENTION!
Before moving the appliance, disconnect the
power supply and any mechanical stops.
Remove any containers or objects on them.
NEVER move the trolley when it is still connected
to the power
REFERENCE STANDARDS
The appliance is manufactured in compliance with the
following European Directives:
• LOW VOLTAGE DIRECTIVE 2006/95/EC
• ELECTROMAGNETIC COMPATIBILITY
DIRECTIVE 93/68/EEC
ELECTRICAL CONNECTION
The trolley has a spiral cable and Schuko socket of
suitable length and section. Before connecting to the
power supply, make sure:
9a suitable cutout switch is installed between the
power outlet and the electric line
9Appliance max. leakage current is 1mA/kW.
9The electrical safety of this appliance is
guaranteed only when it is connected to an
efficient earthing system.
The Manufacturer declines any liability if the
accident-prevention regulations are not
respected.
POSITIONING
Unpack the appliance and carefully remove the
protective film, making sure no traces of glue remain;
if necessary, remove any traces with a suitable
solvent.
For disposal of the packing, see "DISPOSAL" in the
section "THE ENVIRONMENT".
OPERATING INSTRUCTIONS
This appliance must only be used for its expressly
designed purpose, i.e. for keeping food hot above
65°C and in the right humidity conditions.
It can also be used as a dish warmer trolley.
Any other use is deemed improper.
STARTING
For the humidifying function, the appliance needs to
be filled with approx. 1.5 litres of water,
corresponding to a level of approx. 2.5 cm in the tank.
To access the tank, located in the middle of the trolley
bottom, just lift the breakwater cover using the special
hole. Remember to close the drain cock located
under the trolley before filling the tank.
9Turn the knob “1” clockwise fig. 1.
Lighting up of indicator signals that the appliance is
on.
9Turn the knob of the thermostat “2” to the
required heating temperature setting (between
30°C and 90°C).
Lighting up of indicator signals that the heating
elements are on; it goes off when the set temperature
is reached. The current compartment temperature is
displayed.
9Turn the knob of the humidistat “3” to the required
humidity setting.
Lighting up of indicator signals that the steam
generator heating elements are on.
At the end of the service, turn the knob “1”
anticlockwise to switch the trolley off. All the
indicators go off.
ENGLISH

CLEANING AND MAINTENANCE
ATTENTION!
Do not carry out maintenance operations with the
appliance plugged in, or start it without the
covering panels properly fitted.
Use protective gloves during all maintenance
operations!!
Remove any scale deposits from the tray with vinegar
or specific scale removers available on the market,
following the supplier's instructions.
Clean the stainless-steel parts with lukewarm soapy
water, then rinse and dry thoroughly.
NEVER use detergent products containing abrasive
or corrosive substances, shavings, scouring pads,
common steel brushes or scrapers to clean the
stainless-steel surfaces.
Check the power cable regularly and have it replaced
in case of signs of wear.
Idle periods
During long appliance idle periods, take the following
precautions:
9disconnect the power supply;
9go over all the stainless-steel surfaces vigorously
with a cloth moistened with paraffin oil in order to
create a protective film;
9store the unit in a dry and well-aired place.
Have the entire appliance checked periodically (at
least once a year).
THE ENVIRONMENT - PACKING
The packing materials are environmentally friendly
and can be stored without risk or burned in an
appropriate waste incineration plant.
Recyclable plastic components are marked with:
Polyethylene: outer wrapping, instruction
booklet bag.
Polypropylene: straps.
Polystyrene foam: corner protectors,
padding.
CLEANING
In order to reduce the emission of pollutants into the
environment, it is advisable to clean the appliance
(externally and when necessary internally) with
products that are more than 90 % biodegradable.
DISPOSAL
Do not disperse in the environment. Our appliances
are manufactured using recyclable metal materials.
Make the appliance unusable by removing the power
cable and any compartment or cavity closing
devices(when present) in order to avoid the risk of
someone becoming trapped inside.
For further information regarding the recycling of this
product, contact the product agent or local dealer, the
after-sales service or the local body responsible for
waste disposal.
The Manufacturer reserves the right to change the
characteristics of the appliance described in this
publication without notice.
ENGLISH