Elite Screens Elite Tripod Series User manual

Tripod-Portable Screen
Elite Tripod Series
USER’S GUIDE
Rev 1.1

Using the Screen
1. a) Turn the screen in a 90-degree horizontal position and b) pull up the extension
bar up to the desired screen position and c) push down the tripod legs to make the
screen stable. (Fig 1)
Fig. 1
c
b
a
2. Follow the steps illustrated on Fig. 2, steps 1-2-3-4 to pull the screen handle up
smoothly and vertically to have the screen on the end of the extension bar (Fig 6),
you can repeat steps 2-3-4 to adjust different height. Repeat 4-5-4 to adjust the
low level height.
Fig. 2
5
3
4
2
1
3. Reverse the steps above to pack up the screen and put away. Hold the extension
bar (Position 3 in Fig. 7) and use another hand to unlock position 2 (Fig. 7). It is
very important to remember to hold the extension and then unlock, or it will cause
damage to the screen.
Rev 1.1

Fig. 3
4. Turn the screen in a vertical position as shown in step 1 (Fig. 3) to fix the screen
and then tighten up the bar on step 2 (Fig. 3)
Note 1: To ensure the screen is stable, extend the tripod’s legs as much as possible.
Do not fold the screen or allow any sharp objects to touch the screen’s surface.
Clean the screen surface often when needed.
Careful use will extend the lifetime of this product.
Note 2: You can also use the Hand Roller on the side of the projection screen (Fig. 2) to
adjust the screen height. Unlock the position on step 4 in Fig. 2 and roll the Hand Roller
up or down
Contact info:
, Inc
www..elitescreens.com
[email protected]
Rev 1.1