Enclume Dr32 User manual

Enclosed you will find everything needed for the assembly

and use of your storage rack. Two people make assembly

and installation easier. The parts and hardware included are:

Hardware included:

2 – Ceiling Screw Hooks

4 – 1"1/4 x 5/16"Button Head Screws

2 – 7/8" x 5/16" Button Head Screws

2 – 5/16"Hex Nuts

1 – 3/16"Allen Wrench

2 – 5"Extension Hooks

Components included:

1 – Oval Base

4 – Arms

1 – Upper Cross Bar

1 - Grid

6 – Angled Pot Hooks

6 – Straight Pot Hooks

See reverse side for ASSEMBLY AND INSTALLATION INSTRUCTIONS

Décor Oval with Wood

DR32

Thank you for choosing Enclume!

Enclume racks are the ultimate quality,

design, strength and function.

WARNING: READ ALL OF THE

INSTRUCTIONS BEFORE

ASSEMBLING AND USING YOUR

RACK

ASSEMBLY AND INSTALLATION INSTRUCTIONS

Rack Assembly

1) Locate the hardware bag containing the button head screws and allen wrench. Loosen one of the button head screws on the oval

a few turns to allow for attaching the arm/grid bracket on the inside of the rack with the L on the arm facing inward. Using the

loosened button head, screw into the tapped hole on the arm. Do not tighten. Repeat for each of the remaining 3 arms.

2) Attach the arms to the upper cross bar with the 7/8"x 5/16"button head screws and the 5/16"hex nuts.

3) Square up the rack by aligning the arms so they are perpendicular to the upper and the lower oval. Tighten all of the button head

screws.

4) Place the grid on the “L” brackets.

5) Place the 5"extension hooks in the holes on the upper cross bar to hang from your installed ceiling screw hooks or eyebolts.

6) For your safety, distribute your cookware evenly. Hang your pot hooks from the interior squares only. Do not hang them from

the perimeter or the cut portions of the grid.

Installation:

1) We recommend that you anchor your rack into the solid wood of ceiling joists or beams. Carefully measure the area where

the rack is to be hung and install the ceiling screw hooks directly into the wood joists. If you have a special situation such as

steel joists or masonry, please contact your local hardware store or contractor for expert advice.

2) If it is not convenient to hang your rack directly into wood joists you may use the DRYWALL anchors not included.

It is important that your rack is assembled correctly. If the unit is not assembled

correctly or is used improperly, it could become unstable, possibly causing injury.

Limited Warranty: This product is warranted to be free of material defects for a period of five years from the date of purchase. Customer's exclusive remedy shall

be the repair or replacement of the defective product and shall be subject to the following conditions: (1) notice of any defect is received by Enclume within the

warranty period and (2) customer returns the defective product to Enclume Design Products, 24 Colwell St. , Port Hadlock, WA 98339, postage prepaid within 20

days following a return authorization number (which may be obtained by telephoning the number at the top of this instruction) being provided to the customer by