SMITH SYSTEM Planner Studio Bench User manual

Assembly Instructions
Planner Studio Bench
If you have damaged or missing components,
please contact customer service at 1-800-328-1061
Document #: 179670 REVISED: 08/2020

Hardware and Components
Document #: 179670 REVISED: 08/2020
12” DEEP BENCH LEG BASE
QTY. 2
24” DEEP BENCH LEG BASE
QTY. 2
#10 X 3/4”WOOD SCREW
12” DEEP: QTY. 22
24” DEEP: QTY. 36
BENCH TOP
12” DEEP: QTY. 1
24” DEEP: QTY. 2
BENCH SUPPORT CHANNEL
12” DEEP: QTY. 1
24” DEEP: QTY. 2
3/16”ALLEN WRENCH
QTY. 1
1/4”-20 X 3” BOLT
12” DEEP: QTY. 6
24” DEEP: QTY. 12
1/4”-20 LOCK NUT
12” DEEP: QTY. 6
24” DEEP: QTY. 12
GLIDE INSERT
QTY. 4 GLIDE QTY. 4

Special Notes:
•TOOLS REQUIRED:
•Drill w/#2 Phillips driver bit, or #2 Phillips head screwdriver.
•7/16” socket & ratchet, or 7/16” wrench.
•Hammer
•Check that all components are accounted for and undamaged before assembling.
•Please assemble the product in a clean and dry area.
•Clean the product with a mild cleaner and a damp cloth.
Document #: 179670 REVISED: 08/2020

Assembly Instructions
Document #: 179670 REVISED: 08/2020
1. Lay top down on a clean smooth surface that will not harm the top finish. Underside
of top should be exposed.
2. For the 24” deep bench, lay both tops down on a clean smooth surface that will not
harm the top finish. Underside of tops should be exposed. Arrange tops as shown with
pre-drilled holes closest to the edge facing inwards. Leave about 1/2” gap between the
tops.
½”

Document #: 179670 REVISED: 08/2020
3. Position the support channel(s) onto the top, as shown. Do not attach support
channel to top yet. First attachthe legs, one at a time, to the support channel(s) by
using the supplied 1/4”-20 x 3” bolts and 1/4”-20 lock nuts.
Helpful Hint: The nut goes on the inside; bolt head seen on the outside.
Helpful Hint: Make sure legs are facing the right direction, as shown.

Document #: 179670 REVISED: 08/2020
4. Lay assembled frame on top and line up holes on frame with the hole pattern on the
top.

Document #: 179670 REVISED: 08/2020
5. Attach the frame to the wood top using #10 x 3/4” wood screws.

Document #: 179670 REVISED: 08/2020
6. Hammer in glide inserts into the legs. Make sure to carefully trim off any excess
plastic between the edge of the leg and glide insert.
7. Install glides by screwing them into the glide inserts.

Document #: 179670 REVISED: 08/2020
8. Flip bench over.
ASSEMBLY COMPLETE