Ercol Rimini User manual

Pre-assembly preparation
Please ensure instructions are read in full before attempting to assemble this product
Necessary Tools
This item is HEAVY
Please check the pack contents before attempting to assemble this product. A full checklist of components is
given in this leaflet. If any components are missing, please contact the retailer from whom you bought this
product.
This product is HEAVY, it should be assembled as near as possible to the point of use. TAKE CARE WHEN
LIFTING to avoid personal injury and (or) damage to the product.
This product takes approximately 20 MINUTES to assemble with 2 PEOPLE.
The fittings pack contains SMALL ITEMS which should be KEPT AWAY FROMYOUNG
CHILDREN.
ercol
Thank you for purchasing this Rimini chest. Please read the instructions carefully before use to ensure safe and
satisfactory operation of this product.
Rimini compact bedside chest
Installation shall be carried out exactly according to the manufacturers
instructions, otherwise a safety risk can occur if incorrectly installed.
WARNING: In order to prevent overturning this product must be used with the wall attachment device provided.

Fittings and parts checklist
Wall fixing - if in doubt seek professional advice
Wood
If fixing to wood
make sure that it
isn’t chipboard as
screws can easily pull
away from the core
structure
Brick or Masonry
Use an appropriate
wall plug provided you
are sure your wall is
sound
Cavity wall
Special toggle
wall plugs are
needed. Seek
expert advice
1. See fig 1 below. Screw one of the brackets on to the back of the chest in the middle, using the short
screws provided. Make sure the TOP OF THE BRACKET IS BELOW the top of the chest. Position the
chest against the wall where you want it to go, place the second bracket onto the wall below the one
fixed to the chest and mark where the holes come on the wall. Move the chest away from the wall.
2. Attach the wall bracket using screws suitable for your type of wall, see Wall fixings above.
3. Place the chest back against the wall so the two brackets match up and tie them together with
the plastic strap provided . The plates need not match exactly, but the plastic tie must go through
each plate. Close the strap, but do not over tighten it. See diagrams below.
A 16mm Screws x 1 C
Brackets x 2
B Wedges x 2
Strap x 1

4. If the chest is not level on your floor use the wedges provided, and snap them off so that they
do no Protrude out from the cabinet’s legs,you can also snap them lengthways if desired.
PLEASE KEEP THESE INSTRUCTIONS FOR FUTURE REFERENCE
Ercol Furniture Ltd, Summerleys Road, Princes Risborough, Buckinghamshire. HP27 9PX www.ercol.com