ETEKCITY Luminary EKS-L221-SUK User manual

1
Luminary™Kitchen Scale
Model: EKS-L221-SUK
User Manual
Questions or Concerns?
[e-mail]

2
Thank you for purchasing the
Luminary™Kitchen Scale by Etekcity.
If you have any questions or concerns, please reach out to our
helpful Customer Support Team at [e-mail].
We hope you enjoy your new kitchen scale!

3
Package Contents
Specications
Important Safety Information
Function Diagram
Display Diagram
Using Your Scale
Troubleshooting
Warranty Information
Customer Support
Table of Contents
Package Contents
1 x Luminary Kitchen Scale
1 x USB Charging Cable
1 x Quick Start Guide
3
4
5
7
8
9
12
14
15

4
Specications
Weight Capacity 10 kg / 10000 mL / 353 oz / 22 lb
Units g / mL (water/milk) / ’oz (water/milk) /
oz / lb:oz
Increments 1 g / 0.05 oz
Auto-Off 180 seconds
Battery 300mAh Li-ion Battery
Input 5.0V 500mA (USB Type-C Charging)
Dimensions 230 x 170 x 27 mm / 9.1 x 6.7 x 1.1 in

5
Scale
Important Safety Information
• Do not exceed the 10 kg / 22 lb weight capacity, as it will damage
the scale. An error indicator will appear on the LED display if the
limit is exceeded.
• The scale is IPX6 water resistant, which means it can withstand
most liquid spills without permanent damage. However, we still
recommend wiping the scale dry with a soft cloth after any spills
to keep it in optimal condition.
• Handle with care. This scale is not intended for commercial or
heavy-duty use.
• Keep the scale in a cool, dry place. Avoid exposure to damp
environments or extreme temperatures.
• Household use only.
To avoid damage to this scale, please read and follow all
instructions and safety guidelines in this manual.
READ AND SAVE THESE INSTRUCTIONS

6
Batteries
• The display will show “LO” when the battery needs to be charged.
• Insert the USB charging cable into the USB charging socket.
• Plug the USB charging cable into a DC 5V adapter and plug into an
outlet. You can also plug the cable into a powered USB outlet.
• When charging, the battery symbol ( ) on the display will light up.

7
Function Diagram
A. LED Display
B. Unit Selection Button
C. Power/Zero Button
D. Locking Key (Hold Button)
E. USB Charging Port
F. Anti-Skid Pads
BF
E
CD
A
Top Bottom

8
Display Diagram
A. Battery Charging Indicator
B. Milk
C. Water (Liquid)
D. Tare Indicator
E. Weight Value
F. Measurement Unit
G. Hold Indicator
A
B
C
D
G
F
E

9
Using Your Scale
General Operation
1. Place the scale on a hard, at surface.
2. Tap to turn on the scale. Make sure the display reads
“0.00”.
3. Tap UNIT to select your desired measuring unit, which will
show on the right of the display.
4. Place your item on the scale.
5. Wait for the reading on the display to stabilise.
6. When you’re done, reset the scale by removing all items from
the scale. If the display doesn’t read “0.00”, press to
reset the weight to zero.
Note:
• For accurate results, always place the scale on a hard, at surface, and
keep the scale away from dirt, dust, vibrations, wind, air currents, and
electromagnetic interference.
• When you turn on the scale, choose units, or use the tare function, wait
for the display to read “0.00” before measuring.

10
1. Tap to turn on the scale. Make sure the display reads
“0.00”. If the screen does not display “0.00” automatically, tap
to adjust to zero.
2. Place the container on the centre of the scale.
3. Wait for the reading on the display to stabilise. The display will
show the container’s weight.
4. Tap to tare the weight of the container. The screen will
now display “0.00”.
5. Place the liquid or items into the container. The scale will
measure the contents without including the weight of the
container.
6. When you’re done, reset the scale by removing all weight and
tapping again.
Whenever you measure items inside a container, you can use
the tare function to remove the container’s weight from the nal
measurement.
Zero / Tare Function

11
Unit Conversion
Hold Function
Automatic Power Off
Manual Power Off
To change the unit of measurement, tap UNIT until the display
shows your desired unit of measurement.
Tap HOLD to lock the measurement data on the display. Tap
HOLD again to unlock the display.
To save battery power, the scale will automatically power off after
180 seconds of inactivity.
Tap and hold for 2 seconds to turn off the scale.
Note: In hold mode, will not work. You can still use UNIT to switch
between units.

12
Troubleshooting
If your problem is not listed, please contact Customer Support
(see page 15).
Problem Possible Solution
Scale does not turn on. The scale may need to be charged. Plug in the USB
power cord and charge for 2 hours.
Reading is inaccurate.
Place scale on a level surface.
Keep scale away from dirt, dust, vibrations, wind, air
currents, and electromagnetic interference.
Make sure the screen displays “0.00” before measuring
(see Zero / Tare Function, page 10).
Display shows “Err”
Item is too heavy. Remove item from scale to protect
its weight sensor. Use a different scale with a higher
weight range.
Display shows “Lo” Battery power is low. Plug in the USB power cord to
charge the scale.
This product is RoHS compliant. This product is in compliance with Direc-
tive 2011/65/EU, and its amendments, on the restriction of the use of cer-
tain hazardous substances in electrical and electronic equipment.
This symbol means the product must not be discarded as household
waste, and should be delivered to an appropriate collection facility for
recycling. Proper disposal and recycling helps protect natural resources,
human health and the environment. For more information on disposal and
recycling of this product, contact your local municipality, disposal service,
or the shop where you bought this product.

13
To remove the batteries from your equipment or remote control, reverse the procedure de-
scribed in the owner’s manual for inserting batteries. For products with a built-in battery that
lasts for the lifetime of the product, removal may not be possible for the user. In this case,
recycling or recovery centers handle the dismantling of the product and the removal of the bat-
tery. If, for any reason, it becomes necessary to replace such a battery, this procedure must be
performed by authorized service centers. In the European Union and other locations, it is illegal
to dispose of any battery with household trash. All batteries must be disposed of in an environ-
mentally sound manner. Contact your local waste-management ocials for information regard-
ing the environmentally sound collection, recycling and disposal of used batteries.
WARNING: Danger of explosion if battery is incorrectly replaced. To reduce risk of re, explo-
sion or leakage of ammable liquid/gas, don’t disassemble, crush, puncture, short external con-
tacts, expose to temperature above 60°C (140°F), sunshine or like, expose to extremely low air
pressure or dispose of in re or water. Replace only with specied batteries. The symbol indi-
cating ‘separate collection’ for all batteries and accumulators shall be the crossed-out wheeled
bin shown below:
Instructions for Users on Removal,
Recycling and Disposal of Used Batteries
According to EU Batteries Directive 2013/56/EU, any batteries, accumulators and button cells
containing more than 0.0005 % mercury, more than 0.002 % cadmium or more than 0.004 %
lead, shall be marked with the chemical symbol for the metal concerned: Hg, Cd or Pb respec-
tively. Please Refer to the symbol below:
Hg Cd Pb

14
Warranty Information
Product Luminary Kitchen Scale
Model EKS-L221-SUK
For your own reference, we strongly recommend that you record your order ID and
date of purchase.
Order ID
Date of Purchase
TERMS & POLICY
Etekcity Corporation warrants all products to be of the highest
quality in material, craftsmanship, and service, effective from the
date of purchase to the end of the 2-year warranty period.
If you have any questions or concerns about your new product,
please contact our helpful Customer Support Team.

15
Customer Support
Etekcity Corporation
1202 N. Miller St., Suite A
Anaheim, CA 92806
USA
Email: [e-mail]
* Please include your order ID when contacting customer support.

16
NF111221AL-M2.1_0921EKS-L221-SUK
Connect with us @EtekcityUK