EXFO FTB-2 User manual


FTB-2/FTB-2 Pro and FTB-4 Pro
Accessing Connectors and Ports
Headset/microphone port
(for 3.5 mm connectors)
External monitor port
(for monitors compatible with a DisplayPort interface)
USB 2.0 host port
Ethernet (RJ-45) port
USB 2.0 host port
USB 3.0 host port
Module slots
(two or four slots,
depending on models)
Stylus
Built-in power meter and VFL (optional)
Replacing Batteries
1
2
3
4
Position the unit so that its front panel rests on a flat surface such as a table.
Lift.
Turn the screws counterclockwise until
the compartment door is loose.
Remove.
Charging Batteries
Connect your unit to AC
power with the provided
AC adapter/charger (FTB-2
and FTB-2 Pro) or
power cord (FTB-4 Pro).
Pull on the battery’s tab to free it
from its socket. 5
Slide in the new battery (poles facing down
and pointing towards the back of the
battery socket). 6
7Put back in place.
While applying slight pressure, turn the
screws clockwise until they are tightened.
8
Battery status LED
Green: Fully charged
Green, blinking: Charging
Yellow: Battery level is low
Quick Reference Guide
© 2017 EXFO Inc. All rights reserved.
Printed in Canada (2017-03)
P/N: 1070843 Version: 3.0.0.1 For more information,
refer to the user guide.

Keyboard/screen capture button
Press once to show the on-screen keyboard.
Press once again to hide it.
Hold down for a few seconds to take a screen capture.
Task-switching button
Press once to view the list of running applications.
Press as many times as needed to select the
desired application.
On/Off button
Press for one second to turn the unit on.
Press for one second to send the unit to sleep (default behavior).
Using Your Unit
Information about the inserted module To start the applications related to
the module
Button bar
To access modules and instruments, test tools,
utilities, documentation, and to configure your unit
To retrieve information about your unit
To view the online help
Inserting Modules
1
For an FTB module,
press to turn off your
unit.
CAUTION
For FTB modules: Never insert or remove a module while the unit is
turned on. This will result in immediate and irreparable damage to
both the module and unit.
For FTBx modules: There is no need to turn off your unit before
inserting or removing modules. However, to remove them properly
and avoid problems, follow the instructions from the user guide.
2Place the module vertically so that you can
see its faceplate and the protruding edges are
on the left side.
3Insert the protruding edges of the module into
the grooves and push all the way to the back.
4Secure the module.
For an FTBx module, turn
the two retaining screws
clockwise.
For an FTB module, turn the
retaining screw (located on
the left panel) clockwise.
For heavier FTB modules such as the OSA or the FTB-88100NGE
PowerBlazer, secure the module with front locking screws
(turn clockwise).
5
Module adapters (must be installed before inserting FTB modules)