Felix Storch Pro BIOprinter User manual

How to perform well plate printing
13 July 2021
Revision 0
FELIX Pro BIOprinter

How to perform well plate printing
13 July 2021
1
FELIX BIOprinter
www.FELIXprinters.com
Introduction
1Introduction
Thank you for choosing FELIXprinters!
It is highly recommended to read this manual. It explains in short how to make your first print and contains essential
tips to operate the printer properly.
If you are unable to continue or have any questions, you can check at the support section of our website or you can
contact us directly:
Website: www.felixprinters.com/support
Email: [email protected]m
Telephone: [phone]
Address: Zeemanlaan 15, 3401MV IJsselstein, The Netherlands
Kind regards,
FELIXprinters

How to perform well plate printing
13 July 2021
2
FELIX BIOprinter
www.FELIXprinters.com
Introduction
1. Import the well plate printing factory file.
The STL files should load including all processes:
Please inspect the print settings per process. (nozzle diameter and temperatures etc)

How to perform well plate printing
13 July 2021
3
FELIX BIOprinter
www.FELIXprinters.com
Introduction
2. Press “Prepare to print”
Select all Processes
Choose sequential printing
Then press ok
3. Inspect the sliced object
Select the correct preview settings and check:
-Printhead really travels to the next object with only ONE move after finishing the object.
4. Save the gcode to disk.
5. Press exit preview mode and press preview gcode

How to perform well plate printing
13 July 2021
4
FELIX BIOprinter
www.FELIXprinters.com
Introduction
6. OPEN the file again in simplify3D,
7. Inspect travel motion from one object to the next, should now include a hop of about 25mm
8. Now upload the gcode to the printer and start the print.

How to perform well plate printing
13 July 2021
5
FELIX BIOprinter
www.FELIXprinters.com
Introduction
If you are unable to continue or have any questions, you can check at the support section of our website or you can
contact us directly:
Website: www.felixprinters.com/support
Email: [email protected]m
Telephone: [phone]
Address: Zeemanlaan 15, 3401MV IJsselstein, The Netherlands
Kind regards,
FELIXprinters