FIBARO FGFS-101-ZW5 User manual

INSTRUCTION MANUAL
FIBARO SYSTEM
FLOOD SENSOR

Technical support
Should youneed any assistance in connecting or
configuring your Home Center, please use our guides
and technical presentations which can be found on
our website:
http://www.baro.com/us/support
For all other questions email our support team:
[email protected]
Note: The Flood Sensor works with most Z-Wave
Controllers such as Home Center 2, Home Center Lite,
SmartThings, Vera, Nexia, and HomeSeer.
*Does not currently work with Wink.

Water sensor Temperature
sensor
Functional features
Tilt sensor
Siren and light
alarm

Download FIBARO app for
smartphone

Start the device
Twist and open the
casing.
STEP 1
Take off the casing.
STEP 2

Beep!
STEP 3
Remove the battery blocker
“I’m ready”.
Start the device
You will hear a beep while
LED diode blinks red.
Check if the battery
is placed correctly.
STEP 4

Your Flood Sensor is ready to
be added to the Home Center.
Flood Sensormust be in range of the Home
Center because it requires a direct
communication with the controller.

Start inclusion mode
STEP 5
Start your FIBARO
application. Go to
Settings.

Start inclusion mode
STEP 7
STEP 6
Press
“Next”.
Press
“add device”.

Inclusion mode has been launched
Still need help? Watch the Inclusion video

Add your device
STEP 8
Quickly, triple click the
button in order to add your
device to the system.

Processing your con igurations

STEP 9
Quickly, triple click the button
in order to wake up the device.
Wake up the device
Sometimes waking up the device is not
required so it will be omitted automatically.
Still need help? Watch the Wake Up the Device video

The device has been added
Name the device
and assign it to the
room.
STEP 10

STEP 11
Hold the button for about 10-15
seconds until LED diode blinks violet.
STEP 12
Release the button, and
press it again.
Network range test
It is recommended to check if the device’s destination
is in range of your Home Center.
The quality of the
network range will be
indicated by different
colors of the LED diode.

Network range test – quality indicator
Direct
communication
Routed
communication
Limited
communication
No signal! The device
will not work correctly!
STEP 13
Press the button in order
to leave testing mode.
Still need help? Watch the Network Range Test video

Close and twist
the cover.
STEP 14
Close the casing

3. A built-in temperature sensor lets
you monitor e.g. frozen pipes.
1. FIBARO Flood Sensor should be installed
in all spaces, where’s the risk of flood:
• In the bathroom,
• In the kitchen,
• At the basement.
2. Additional security informs about
accidental location change (every time it
changes its location in information is being
sent to Home Center).
Installation
During the installation it is recommended to wake up the
device.

Adding a probe
If the sensor cannot fit the space which is in danger of flooding you
can install a wired probe* that will get to difficult
to access spaces.
*The probe is not
included in the Flood
Sensor set.
Install the probe here

www.fibaro.com