Fike FIK-RA100BD Technical manual

PN LS10260-001FK-E:A 03/03/2021 ECN: 151526
FIK-RA100BD
Product Installation Document
FIKE CORPORATION
704 SW 10th Street
Blue Springs, MO 64015
www.fike.com
1 Description
The FIK-RA100BD is the replacement annunciator board used with the Fike Series, ECS System. The FIK-RA100BD is housed in the Fike
Series, ECS fire alarm control panel (FACP) cabinet. The FIK-RA100BD is housed in the FIK-RA100 remote annunciator cabinet.
1.1 Compatibility
The FIK-RA1000BD is compatible with the Fike Series, Fire Alarm Control Panels (FACPs).
1.2 Specifications
2 Mounting
1. Remove the AC power from the ECS FACP.
2. Open the cabinet to access the annunciator board.
3. Remove the FIK-RA100 from its mounting location as shown in Figure 1.
4. Install the new annunciator board.
Figure 1 FIK-RA100 Mounting Screws
NOTE: The installation and wiring of this device must be done in accordance with the NFPA 72 and the local ordinances.
NOTE: For more information, see the FACP Installation Manual.
• Standby Current: 20 mA
• Alarm Current: 25 mA
• Operating Voltage: 24VDC
• Operating Temperature: 32°F to 120°F (0°C to 49°C)

2 FIK-RA100BD Product Installation Instructions — P/N LS10260-001FK-E:A 03/03/2021
3 Wiring the FIK-RA100BD
To wire the FIK-RA100BD, refer to Table 1 and Figure 2.
Figure 2 shows the wiring connections of the FIK-RA100BD to the FACP.
Figure 2 Wiring the FIK-RA100BD
4 Programming
The FIK-RA100BD must have the dip switches set to match the existing FIK-RA100BD, if possible. See Figure 3 for the device IDs and the
corresponding dip switch settings. If you match the existing device ID, you need to program the new FIK-RA100BD. If you use a different
device ID, you must program the FIK-RA100 into the Fike, ECS FACP. For programming information, refer to the Fike Series, ECS Installa-
tion Manual (PN LS10262-001FK-E).
Figure 3 DIP Switch Settings for the FIK-RA100BD Device ID
FIK-RA100BD
Terminals
ECS FACP
SBUS Terminals
SB B
SA SA
S+ +
S– –
Table 1 FIK-RA100BD to ECS FACP Terminal Connections
FIK-RA100BD
*Note: Address 0 cannot be used.