Fisher-Price C6325 User manual

Please keep this instruction sheet for future reference, as it contains important information.
Requires three “AA” batteries (included).
Adult assembly is required for battery replacement.
Tool required for battery replacement: Phillips screwdriver (not included).
www.fisher-price.com
C6325

1,5V x 3
“AA”(LR6)
Battery Safety Information
A plastic tab was attached to the toy for in-store
demonstration purposes. While the tab may
have already been removed, check the back
of the toy to be sure. If the plastic tab is still
attached, open the fasteners on the back of
the toy and pull and remove the tab. Close
the fasteners and throw the plastic tab away.
Before Use
For best results, we recommend replacing
the batteries that came with this toy with
three, new “AA” (LR6) alkaline batteries.
• Open the fasteners on the back of the toy to
access the battery compartment.
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove it. Throw the
exhausted batteries away.
• Insert three, new “AA” (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screw. Do not over-tighten.
• Close the fasteners on the toy.
• If the toy begins to operate erratically you
may need to reset the electronics. Slide the
power/volume switch on the back of the toy
off and then back on.
• When sounds become faint or stop, it’s time
for an adult to change the batteries!
•Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for recycling
advice and facilities.
Battery Replacement
Power/Volume
Switch
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product.
To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
•
Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type,as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
2 Interactive Play Modes!

• Open the fasteners on the back of the toy and slide the power/volume to ON with
low volume ; ON with high volume ; or OFF .
• Locate the mode select switch on puppy's right foot.
• Press the right foot to turn the toy on and start in learning mode. Press again for music mode.
Press once more to turn the toy off.
2 Interactive Play Modes!
Mode Select
Music Mode
• Press the puppy's left foot, right hand,
heart, tummy or left ear to hear it
identified followed by a short ditty. Press
again to learn a color.
• Press the note button on the puppy's
left hand to hear fun learning songs.
• Press the puppy's left foot, left ear, heart or
hands to hear a fun song. Press again to
hear a fun phrase.
• Press the puppy's tummy to hear another
fun song. Press again to hear the puppy
giggle and bark.
Learning Mode

Fisher Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. C6325a–0923
©2011 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. PRINTED IN CHINA
CONSUMER ASSISTANCE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa, B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
Consumer Information
FCC Statement (United States Only)
This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there is
no guarantee that interference will not occur
in a particular installation. If this equipment
does cause harmful interference to radio or
television reception, which can be determined
by turning the equipment off and on, the user
is encouraged to try to correct the interference
by one or more of the following measures:
•
Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/
TV technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) this device may
not cause harmful interference and (2) this
device must accept any interference received,
including interference that may cause
undesired operation.
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il
ne doit pas produire de brouillage et (2)
l’utilisateur du dispositif doit être prêt à
accepter tout brouillage radioélectrique
reçu, même si ce
brouillage est susceptible de
compromettre
le fonctionnement du dispositif.