Fisher-Price DYM91 User manual

DYM91
fisher-price.com
Keep this instruction sheet for future reference,
as it contains important information.
Requires three AA batteries (included).
Batteries included are for demonstration purposes only.
Battery replacement is required. Only adults should install batteries.
Tool required for battery replacement: Phillips screwdriver (not included).
Consumer Information
©2017 Mattel. All Rights Reserved. DYM91-0970
PRINTED IN CHINA 1101720453-DOM
Remark:
Revision Date ID# Changes
Primary - pr 05/24/2017 DYM91-0970-1101720453-DOM NA
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
SOUTH AFRICA: Mattel South Africa (PTY) LTD, Ofce 102 I3,
30 Melrose Boulevard, Johannesburg 2196.
Press bunny’s belly for a soft glow and soothing
music. Press and hold bunny’s belly to turn music
and light off in long play mode.
When you bring this sweet bunny home,
slide the mode switch to long play ,
for longer music and light.

• Open the fasteners on the back of the toy.
Remove the electronics unit from inside
the toy.
1,5V x 3
AA (LR6)
Battery
Replacement
Power and
Mode Switches
• Loosen the screws in the electronics unit
battery compartment door with a Phillips
screwdriver. Remove the door.
• Remove the exhausted batteries and
properly dispose.
• Insert three, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• Fit the electronics unit back inside the toy.
Make sure the button on the electronics unit
is facing the front of the toy.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and then back on.
• When sound or light from this toy become
faint or stop, it’s time for an adult to change
the batteries.
For longer life, use
alkaline batteries.
• Slide the power/volume switch to ON with
low volume , ON with high volume or
OFF .
• Choose a mode and close the fasteners.
Short Play - Watch bunny’s belly
light and Listen to a short song with
each press.
Long Play - Press bunny’s belly for
three minutes of glowing light and about
20 minutes of soothing music. To turn
light back on, press bunny’s belly again.
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable.
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Safety
Information
Care
• This toy is machine washable without the
electronics unit.
• Open the fasteners on the back of the toy.
Remove the electronics unit from inside
the toy.
• Place the toy in a pillowcase. Machine wash
in cold water on the gentle cycle. Do not use
bleach. Tumble dry on low heat.
• Replace the electronics unit back inside the
toy. Open the fasteners on the back of the
toy and fit the electronics unit inside with the
button facing the front of the toy. Close
the fasteners.
Protect the environment by not
disposing of this product or any
batteries with household waste.
This symbol indicates that this
product shall not be treated as
household waste. Check your local
authority for recycling advice
and facilities.

• Open the fasteners on the back of the toy.
Remove the electronics unit from inside
the toy.
1,5V x 3
AA (LR6)
Battery
Replacement
Power and
Mode Switches
• Loosen the screws in the electronics unit
battery compartment door with a Phillips
screwdriver. Remove the door.
• Remove the exhausted batteries and
properly dispose.
• Insert three, new AA (LR6) alkaline batteries.
• Replace the battery compartment door and
tighten the screws. Do not over-tighten.
• Fit the electronics unit back inside the toy.
Make sure the button on the electronics unit
is facing the front of the toy.
• If this toy begins to operate erratically, you
may need to reset the electronics. Slide the
power/volume switch off and then back on.
• When sound or light from this toy become
faint or stop, it’s time for an adult to change
the batteries.
For longer life, use
alkaline batteries.
• Slide the power/volume switch to ON with
low volume , ON with high volume or
OFF .
• Choose a mode and close the fasteners.
Short Play - Watch bunny’s belly
light and Listen to a short song with
each press.
Long Play - Press bunny’s belly for
three minutes of glowing light and about
20 minutes of soothing music. To turn
light back on, press bunny’s belly again.
In exceptional circumstances, batteries may
leak fluids that can cause a chemical burn
injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or batteries
of different types: alkaline, standard (carbon-
zinc) or rechargeable.
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted batteries
from the product. Dispose of batteries safely.
Do not dispose of this product in a fire. The
batteries inside may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent
type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Battery Safety
Information
Care
• This toy is machine washable without the
electronics unit.
• Open the fasteners on the back of the toy.
Remove the electronics unit from inside
the toy.
• Place the toy in a pillowcase. Machine wash
in cold water on the gentle cycle. Do not use
bleach. Tumble dry on low heat.
• Replace the electronics unit back inside the
toy. Open the fasteners on the back of the
toy and fit the electronics unit inside with the
button facing the front of the toy. Close
the fasteners.
Protect the environment by not
disposing of this product or any
batteries with household waste.
This symbol indicates that this
product shall not be treated as
household waste. Check your local
authority for recycling advice
and facilities.

DYM91
fisher-price.com
Keep this instruction sheet for future reference,
as it contains important information.
Requires three AA batteries (included).
Batteries included are for demonstration purposes only.
Battery replacement is required. Only adults should install batteries.
Tool required for battery replacement: Phillips screwdriver (not included).
Consumer Information
©2017 Mattel. All Rights Reserved. DYM91-0970
PRINTED IN CHINA 1101720453-DOM
Remark:
Revision Date ID# Changes
Primary - pr 05/24/2017 DYM91-0970-1101720453-DOM NA
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC rules.
These limits are designed to provide reasonable
protection against harmful interference in
a residential installation. This equipment
generates uses and can radiate radio frequency
energy and, if not installed and used in
accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can be
determined by turning the equipment off and
on, the user is encouraged to try to correct
the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following
two conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired operation.
CAN ICES-3 (B)/NMB-3 (B)
Operation is subject to the following two
conditions: (1) this device may not cause
interference, and (2) this device must accept
any interference, including interference that
may cause undesired operation of the device.
L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes : (1) il ne
doit pas produire de brouillage et (2) il doit
pouvoir tolérer tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible de
compromettre son fonctionnement.
CO
N
SU
MER
ASS
I
S
T
A
N
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
SOUTH AFRICA: Mattel South Africa (PTY) LTD, Ofce 102 I3,
30 Melrose Boulevard, Johannesburg 2196.
Press bunny’s belly for a soft glow and soothing
music. Press and hold bunny’s belly to turn music
and light off in long play mode.
When you bring this sweet bunny home,
slide the mode switch to long play ,
for longer music and light.