Fisher-Price GEO TRAX L5895 User manual

www.fisher-price.com
L5895

A. Span
B. Arch
C. 4 Cable Structures
D. 4 Supports
E. Sports Car
Part not shown: 1 Figure
Parts
A
B C
DE
X2
X2
X4

Battery Installation
Battery Safety Information
In exceptional circumstances, batteries may leak fluids that can cause a chemical burn injury
or ruin your toy. To avoid battery leakage:
• Do not mix old and new batteries or batteries of different types: alkaline, standard (carbon-
zinc) or rechargeable (nickel-cadmium).
• Insert batteries as indicated inside the battery compartment.
• Remove batteries during long periods of non-use. Always remove exhausted batteries from
the toy. Dispose of batteries safely. Do not dispose of the product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the toy before charging.
• If removable, rechargeable batteries are used, they are only to be charged under
adult supervision.
1.5V x 3
“AAA” (LR03)
• Locate the battery compartment on the bottom of the span.
• Loosen the screw in the battery compartment door with a Phillips screwdriver. Remove
the battery compartment door.
• Insert three “AAA” (LR03) alkaline batteries.
We recommend the use of alkaline batteries for longer battery life.
• Replace the battery compartment door and tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• When lights become faint or stop, it’s time for an adult to change
the batteries.
• Protect the environment by not disposing of this product with household
waste (2002/96/EC). Check your local authority for recycling advice
and facilities (Europe only).

Assembly
“Snap” a cable structure
to the side of the span.
CABLE
STRUCTURE
2
• “Snap” the top of the cable structure to
the top of the arch.
• Repeat this procedure to attach the other
three cable structures to the span.
Note: Each cable structure assembles to
the span one way!
3
1
“Snap” the arch onto the span.
ARCH
SUPPORTS
4
“Snap” the supports to the
underside of the span.
SPAN

FCC Statement
United States Only
This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Consult the dealer or an experienced radio/TV technician for help.
Note: Changes or modifications not expressly approved by the manufacturer responsible for
compliance could void the user’s authority to operate the equipment.
Drive Through for a
Rainbow of Lights!
• Locate the power switch on the bottom of
the bridge. Slide the switch to •to turn
the toy on.
• Push the car over the bridge or drive a
train engine (sold separately) over to see
colorful lights. You can also press the
button on the bridge to see the lights.
• Remove the supports to use the bridge at
ground level.
• When you are finished playing with this
toy, slide the power switch off °.
PRESS

Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A. PRINTED IN CHINA
©2007 Mattel, Inc. All Right Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc. L5895pr-0920
Visit www.fisher-price.com to see
the entire world of GeoTrax®accessories!
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AAA” (LR03) alkaline batteries (not included).
Adult assembly is required.
Tool required for battery installation: Phillips screwdriver (not included).
Wipe the toy with a clean, damp cloth. Do not immerse.