Fisher-Price HMF12 User manual

HMF12
Keep this instruction sheet for future reference,
as it contains important information.
Requires three AA batteries (included).
Batteries included are for demonstration
purposes only.
Required tool for battery replacement:
Phillips screwdriver (not included).
Only adults should replace batteries.
Spin the spinner and listen to
fun songs, phrases and music.
Squeeze a feather and Peacock
introduces numbers, colors and
shapes through phrases,
fun sounds and lights!

Battery Safety Information
In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable.
• Insert batteries as indicated inside the
battery compartment (+ and -).
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside
may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
Protect the environment by not disposing
of this product or any batteries with
household waste. This symbol indicates
that this product shall not be treated as
household waste. Check your local
authority for recycling advice and facilities.
Baeries and Power
• Loosen the screw in the battery
compartment door and remove the door.
Remove the exhausted batteries and
properly dispose.
• Insert three, new AA (LR6) alkaline
batteries into the battery compartment.
• Replace the battery compartment door
and tighten the screw.
• Slide the power-volume switch to
ON with low volume, ON with high
volume or OFF.
• When sounds or lights become faint or
stop, it’s time for an adult to change
the batteries.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power-volume switch off and
then back on again.
• To clean, wipe all parts of the toy with
a damp cloth. Do not immerse.
For longer life, use alkaline batteries.
1,5V x 3
AA (LR6)

More Fun with More Than One!
Each sold separately and subject to availability.
Here’s how to sync your Linkimals™toys!
1Turn power OFF on each toy.
2Now turn power ON.
3Watch and listen to Linkimals™toys respond to each other in fun ways during play!
Uh-oh! If, at any time, one of your Linkimals™products doesn’t seem to be interacting
with the other Linkimals™products, turn all of them OFF and then back ON again.
Linkimals™toys are also available in different languages (sold separately and subject to
availability). Linkimals™toys only sync with other Linkimals™toys of the same language.

©2022 Mael.
PRINTED IN CHINA
HMF12-0970-1102936575-DOM
FCC STATEMENT (UNITED STATES ONLY)
This equipment has been tested and found to comply
with the limits for a Class B digital device, pursuant
to Part 15 of the FCC rules. These limits are designed
to provide reasonable protection against harmful
interference in a residential installation. This equipment
generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio
communications. However, there is no guarantee that
interference will not occur in a particular installation.
If this equipment does cause harmful interference to
radio or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by
one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Consult the dealer or an experienced radio/TV
technician for help.
NOTE: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user’s authority to
operate the equipment.
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
This device contains licence-exempt
transmitter(s)/receiver(s) that comply with
Innovation, Science and Economic Development
Canada’s licence-exempt RSS(s). Operation is
subject to the following two conditions:
(1) This device may not cause interference.
(2) This device must accept any interference,
including interference that may cause
undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu
dans le présent appareil est conforme aux CNR
d’Innovation, Sciences et Développement
économique Canada applicables aux appareils
radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes :
(1) L’appareil ne doit pas produire de brouillage;
(2) L’appareil doit accepter tout brouillage
radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement
UNITED STATES
Fisher-Price, Inc., 636 Girard Avenue,
East Aurora, NY 14052. Consumer
Services: 1-800-432-5437.
CANADA
Mattel Canada Inc., 6155 Freemont
Blvd., Mississauga, Ontario L5R 3W2 Consumer
Services/Service à la clientèle : 1-800-432-5437.
www.service.mattel.com.
GREAT BRITAIN
Mattel U.K. Limited, The Porter Building, 1 Brunel Way,
Slough SL1 1FQ, UK. www.service.mattel.com/uk.
NEDERLAND
Mattel Europa B.V., Gondel 1, 1186 MJ Amstelveen,
Nederland.
AUSTRALIA
Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND
16-18 William Pickering Drive, Albany 1331, Auckland.
SOUTH AFRICA
Mattel South Africa (PTY) LTD, Office 102 I3,
30 Melrose Boulevard, Johannesburg 2196.
ÉNONCÉ DE LA FCC (ÉTATS-UNIS SEULEMENT)
Cet équipement a été testé et jugé conforme aux
limites de classe B pour un appareil numérique
en vertu de l’article 15 de la réglementation
de la FCC. Ces limites ont été instaurées pour
fournir une protection raisonnable contre toute
interférence nuisible dans une installation
résidentielle. Cet équipement génère, utilise et
peut émettre de l’énergie radiofréquence. S’il
n’est pas installé et utilisé conformément aux
instructions, il peut provoquer des interférences
sur les communications radio. Cependant,
il n’est pas garanti que des interférences ne
se produiront pas dans certaines installations.
Si cet équipement cause des interférences
à la réception radio ou télévisée (ce qui peut
être vérifié en éteignant l’appareil puis en le
remettant sous tension), l’utilisateur peut tenter
de les résoudre en suivant une ou plusieurs des
mesures ci-après :
• Réorienter ou déplacer l’antenne réceptrice.
• Augmenter l’espace entre l’appareil et
le récepteur.
• Pour obtenir de l’aide, contacter le vendeur ou
un technicien radio/télévision expérimenté.
REMARQUE : Tout changement ou modification
de cet appareil n’ayant pas été expressément
approuvé par les parties responsables de sa
conformité peut entraîner l’annulation du droit
d’exploitation de l’équipement par l’utilisateur.
Cet appareil est conforme à l’article 15 de la
réglementation de la FCC. L’utilisation de ce
dispositif est autorisée seulement aux deux
conditions suivantes : (1) il ne doit pas produire
de brouillage nuisible, et (2) il doit pouvoir tolérer
tout brouillage radioélectrique reçu, même si ce
brouillage est susceptible de compromettre
son fonctionnement.