Fisher-Price Lil' Kingdom Castle C1159 User manual

11
w
w
w.
fi
s
he
r
-p
r
i
c
e
.
c
o
m
C1159
Instructions
Lil‘ Kingdom Castle™
Please keep this instruction sheet for future reference,
as it contains important information.
Requires three “AA” (LR6) alkaline batteries (not included).
Adult assembly is required.
Tool required for assembly: Phillips screwdriver (not included).

2
4 Posts
Castle
Drawbridge
Parts
CAUTION
This product contains small parts in its unassembled state.
Adult assembly is required.
Parts Not Shown:
King Figure
Queen Figure
2 Thrones
Table
Bed
2 Fences
Stable Railing
Horse
Ramp
Spire
Throne with Tube
Balcony
#4 x 3/8" Screw - 8
Shown Actual Size
2 Horns

3
Battery Installation Battery Safety
Information
• Locate the battery compartment on the
bottom of the toy.
• Loosen the screw in the battery compart-
ment door with a Phillips screwdriver.
Remove the battery compartment door.
• Insert three “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline batteries
for longer battery life.
• Replace the battery compartment door and
tighten the screw with a Phillips screwdriver.
Do not over-tighten.
• When sounds or lights from this toy become
faint or stop, it’s time for an adult to change
the batteries.
SHOWN ACTUAL SIZE
Battery Compartment Door
Batteries may leak fluids that can cause a
chemical burn injury or ruin your toy.
To avoid battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated on the battery
compartment.
• Remove batteries during long periods of
non-use. Always remove exhausted
batteries from the toy. Dispose of batteries
safely. Do not dispose of batteries in a fire.
The batteries may explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
toy before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
1.5V x 3
"AA" (LR6)
Bottom View

4
Assembly
Drawbridge
• Position the drawbridge so that the door-
knocker is facing down.
• Insert the peg on one end of the drawbridge
into the hole in the castle.
• Bend the drawbridge slightly and insert the
other peg into the hole in the castle.
1
Throne
with Tube
• Fit the throne tube over the flat post inside
the castle as shown.
Hint: You will need to tip the throne to fit it
into the castle.
Flat Post
2
Fisher-Price, Inc., a subsidiary of Mattel, Inc., East Aurora, NY 14052 U.S.A.
© 2003 Mattel, Inc. All Rights Reserved. ® and ™ designate U.S. trademarks of Mattel, Inc.
PRINTED IN CHINA C1159b-0920
3
Spire
Horn
Peg
• Fit a horn onto a peg on each side of the spire.
• Insert a screw through the hole in each horn.
Tighten the screws with a Phillips screwdriver.
Do not over-tighten.

• Position the spire over the top of the throne
as shown.
• Fit the spire onto the top of the castle, being
sure that the tube on the bottom of the spire
fits over the flat post above the throne.
• Press down on the spire to “snap” it
into place.
5
Assembly
Flat Post
Spire
4
Balcony
•“Snap” the balcony into the slots in the
front of the castle as shown.
5
Tube

6
Assembly
Tab
Ramp
• Align the tabs on the edge of the castle with
the slots in the ramp.
• Fit the tabs into the slots and press firmly
on the castle to “snap” the ramp in place.
• Position the castle so the bottom is facing you.
• Insert two screws through the holes in the
ramp. Tighten the screws with a Phillips
screwdriver. Do not over-tighten.
Post
6
• Fit a fence post over a matching peg on the
bottom of the toy as shown.
• Insert a screw through the post and into the
peg. Tighten the screw with a Phillips
screwdriver. Do not over-tighten.
• Repeat this procedure to attach the other
three fence posts.
7
Bottom View
Bottom View

7
Royal Fun For Everyone!
Push down on the tower flag. The drawbridge lowers,
trumpets blare, lights flicker, and the throne rotates
onto the balcony!
• Fit the tabs on the stable railing
into the slots in the stable.
• Place the horse in the stable.
On/Off Switch
(ON BOTTOM OF TOY)
Slide the On/Off switch to the ●
position to turn the toy on and to
the Oposition to turn it off.

8
FCC Note
(United States Only)
Consumer Information
Note: This equipment has been tested and
found to comply with the limits for a Class B
digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful interfer-
ence in a residential installation. This equip-
ment generates, uses and can radiate radio
frequency energy and, if not installed and
used in accordance with the instructions, may
cause harmful interference to radio communi-
cations. However, there is no guarantee that
interference will not occur in a particular
installation. If this equipment does cause
harmful interference to radio or television
reception, which can be determined by
turning the equipment off and on, the user is
encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not expressly
approved by the manufacturer responsible for
compliance could void the user's authority to
operate the equipment.
Questions? We'd like to hear from you!
Call Fisher-Price®Consumer Relations, toll-free
at 1-800-432-5437, 8 AM - 6 PM EST Monday
through Friday. Hearing-impaired consumers
using TTY/TDD equipment, please call
1-800-382-7470. Or, write to: Fisher-Price®
Consumer Relations, 636 Girard Avenue,
East Aurora, New York 14052.
Care
For countries outside the United States:
CANADA Questions? 1-800-567-7724. Mattel Canada Inc.,
6155 Freemont Blvd., Mississauga, Ontario L5R 3W2.
GREAT BRITAIN Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500302.
AUSTRALIA Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
Consumer Advisory Service 1300 135 312.
NEW ZEALAND 16-18 William Pickering Drive,
Albany 1331, Auckland.
ASIA Mattel East Asia Ltd, Room 1106, South Tower,
World Finance Centre, Harbour City, Tsimshatsui, HK, China.
• Wipe the toy with a clean cloth dampened
with a mild soap and water solution.
• Do not immerse the toy.