Fisher-Price W9860 User manual

Please keep this instruction sheet for future reference,
as it contains important information.
Requires two “AA” (LR6) alkaline batteries (not included) for operation.
Adult assembly is required. Tool required: Phillips screwdriver (not included)
Wipe this toy with a clean, damp cloth. Do not immerse.
This toy has no consumer serviceable parts. Do not take apart.
fisher-price.com
W9860

In exceptional circumstances, batteries
may leak fluids that can cause a chemical
burn injury or ruin your product. To avoid
battery leakage:
• Do not mix old and new batteries or
batteries of different types: alkaline,
standard (carbon-zinc) or rechargeable
(nickel-cadmium).
• Insert batteries as indicated inside the
battery compartment.
• Remove batteries during long periods
of non-use. Always remove exhausted
batteries from the product. Dispose of
batteries safely. Do not dispose of this
product in a fire. The batteries inside may
explode or leak.
• Never short-circuit the battery terminals.
• Use only batteries of the same or
equivalent type, as recommended.
• Do not charge non-rechargeable batteries.
• Remove rechargeable batteries from the
product before charging.
• If removable, rechargeable batteries are
used, they are only to be charged under
adult supervision.
• Protect the environment by not
disposing of this product with
household waste (2002/96/EC).
Check your local authority for
recycling advice and facilities.
Battery
Installation
• Loosen the screw in the battery
compartment door with a Phillips
screwdriver and remove the door.
• Insert two “AA” (LR6) alkaline batteries.
Hint: We recommend using alkaline
batteries for longer battery life.
• Replace the battery compartment door and
tighten the screw. Do not over tighten.
• If this toy begins to operate erratically,
you may need to reset the electronics.
Slide the power/volume switch off and
then back on.
• When sounds become faint or stop, it’s
time for an adult to change the batteries.
Battery Safety
Information
1,5V x 2
“AA” (LR6)

Assembly Whirling Action!
This package contains small
parts. For adult assembly only.
CAUTION
• Fit the handle into the base.
Hint: The handle only fits one way. If it does
not seem to fit, turn it around and try again.
• Insert two M3,5 x 18 mm screws into the
base and tighten with a Phillips screwdriver.
Do not over-tighten.
Handle
Base
Screws
• Slide the power/volume switch to ON with
low volume or ON with high volume .
• Listen to fun sounds while you roll along.
• Roll over a ball to scoop it up. Watch it
whirl around and pop out!
• Drop a ball down the slide and into the base.
• When you are finished playing with this
toy, slide the power/volume switch OFF .
Power/Volume Switch
Power/Volume Switch

©2012 Mattel. All Rights Reserved.
PRINTED IN CHINA W9860pr-0920
FCC Statement (United States Only)
This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide
reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses and can
radiate radio frequency energy and, if not
installed and used in accordance with the
instructions, may cause harmful interference
to radio communications. However, there
is no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interference
to radio or television reception, which can
be determined by turning the equipment
off and on, the user is encouraged to try to
correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the
equipment and receiver.
• Consult the dealer or an experienced
radio/TV technician for help.
Note: Changes or modifications not
expressly approved by the manufacturer
responsible for compliance could void the
user’s authority to operate the equipment.
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference and
(2) this device must accept any interference
received, including interference that may
cause undesired operation.
CO
N
SU
MER A
SS
I
S
TAN
CE
1-800-432-5437 (US & Canada)
1300 135 312 (Australia)
Fisher-Price, Inc., 636 Girard Avenue, East Aurora, NY 14052.
Hearing-impaired consumers: 1-800-382-7470.
Outside the United States:
Canada: Mattel Canada Inc., 6155 Freemont Blvd.,
Mississauga, Ontario L5R 3W2; www.service.mattel.com.
Great Britain: Mattel UK Ltd, Vanwall Business Park,
Maidenhead SL6 4UB. Helpline: 01628 500303.
www.service.mattel.com/uk
Mattel Europa B.V., Gondel 1, 1186MJ Amstelveen, Nederland.
Australia: Mattel Australia Pty. Ltd., 658 Church Street,
Locked Bag #870, Richmond, Victoria 3121 Australia.
New Zealand: 16-18 William Pickering Drive,
Albany 1331, Auckland.
ICES-003
• This Class B digital apparatus complies
with Canadian ICES-003.
• Operation is subject to the following two
conditions: (1) this device may not cause
harmful interference and (2) this device
must accept any interference received,
including interference that may cause
undesired operation.
NMB-003
• Cet appareil numérique de la classe B est
conforme à la norme NMB-003 du Canada.
• L’utilisation de ce dispositif est autorisée
seulement aux conditions suivantes :
(1) il ne doit pas produire de brouillage et
(2) l’utilisateur du dispositif doit être prêt
à accepter tout brouillage radioélectrique
reçu, même si ce brouillage est susceptible
de compromettre le fonctionnement
du dispositif.
Consumer Information