FRAME IT ALL 300001078 User manual

300001078/300001402
300001435/300001451
RAISED GARDEN BED
4’ x 16’
Customer Service: 1800-914-9835 | [e-mail]
© 2020 Frame It All. All Rights Reserved.
Tools needed: Hammer (to tap stake in place), Hackshaw (optional)
Layout your timbers along
the borderline and connect
each timber together by
inserting the top of the stake
through the bracket loops
with the stake pointing to
the sky. This enables you to
freely position your border to
get your desired location.
KIT CONTAINS:
Composite
Timbers x 23
Stacking
Brackets x 34
4-way Bracing
Brackets x 6
Plugs x 92
Caps x 20
Stake x 20

STEP 1: Assemble 14 x Doubled-Bracket Timbers (A)
Attach one single stacking bracket to each end of timbers (one facing up, one facing
down – shown below)
You will need 10 (A) Timbers for the 1st (base) level and 4 (A) Timbers for the 2nd level.
STEP 2: Assemble 6 x Singled-Bracket Timbers (B)
Attach one single stacking bracket to only one end of timbers.
You will need 4 (B) Timbers for the 2nd level.
STEP 3: Assemble 3 x Cross-Bracket Timbers (C)
Attach one 4-way bracing bracket to each end of timbers.
You will need 3 (C) Timbers for the 2nd level.
STEP 4: Arrange 10 (A) Timbers to create the base level of your garden in a straight
rectangular shape – shown below.
Customer Service: 1800-914-9835 | [e-mail]
ASSEMBLY INSTRUCTIONS
Use plugs (included)
to cover the holes on
both side of timbers
X 6
X 3
PLUGS
X 14
Note:
If you plan to assemble raised bed on a hard surface, use
hacksaw to remove the spike of each stake. Use these cut
down stakes for the base level only of your raised garden.
Trim stake spike with
hacksawfor use indoor
or on hard surfaces
X 10

ASSEMBLY INSTRUCTIONS
STEP 5: To create 2nd level, place Cross-Bracket Timbers (C) on top of the 1st level,
To complete the 2nd level, place Single-Bracket Timber (B) with one bracket to
complete the sides and secure the unbracketed timber sides into the channel of the
4-way bracing bracket – see diagram below.
Cross Timber
Connections then add a Single-Bracket Timber (A) on each end
(refer to diagram below).
Customer Service: 1800-914-9835 | [e-mail]
Use plugs (included)
to cover the holes on
both side of timbers
Use plugs to cover
the holes – two
plugs are required
per bracket (1 on
each side)
Use a Finishing
Cap to complete
the top level.
Use an Anchor
or Stacking Joint
for ground level
frames or borders.
Use only Stacking
Joints when
creating additional
levels.
When creating a
multi-level frame
use a Stacking
Joint.
Stacking Joints fitinto
the tops of Anchor
Joints and other
Stacking
Joints
How the Joints Work
STEP 6: Insert a stake through the
brackets into the hole on the top of
the stake beneath it to lock the 2nd
level in place.
STEP 7: Add the caps to each of the
top corner joints and plugs to cover
the holes on both side of timbers.
HAPPY GARDENING!!
C
C
C
A
AA
A
B
B
B
B
B
B