FRAME IT ALL 300001168 User manual

300001168/300001169
300001452/300001436
L-SHAPED RAISED GARDEN
Customer Service: 1800-914-9835 | [email protected]
© 2020 Frame It All. All Rights Reserved.
Tools needed: Hammer (to tap stake in place), Hackshaw (optional)
KIT CONTAINS:
Composite
Timbers x 28
Stacking
Brackets x 40
4-way Bracing
Brackets x 8
Plugs x 112
Caps x 12
Stake x 24
Layout your timbers along the borderline
and connect each timber together by
inserting the top of the stake through the
bracket loops with the stake pointing to the
sky. This enables you to freely position your
border to get your desired location.

Customer Service: 1800-914-9835 | [email protected]
ASSEMBLY INSTRUCTIONS
STEP 1: Assemble 18 x Doubled-Bracket Timbers (A)
Attach one single stacking bracket to each end of timbers (one facing up, one facing
down – shown below)
You will need 12 (A) Timbers for the 1st (base) level and 6 (A) Timbers for the 2nd level.
STEP 2: Assemble 6 x Singled-Bracket Timbers (B)
Attach one single stacking bracket to only one end of timbers.
You will need 6 (B) Timbers for the 2nd level.
STEP 3: Assemble 4 x Cross-Bracket Timbers (C)
Attach one 4-way bracing bracket to each end of timbers.
You will need 4 (C) Timbers for the 2nd level.
STEP 4: Arrange 12 (A) Timbers to create the base level of your garden in a straight L-
shape – shown below. Insert one stake through the brackets and into each of the
corners to lock all sides in place.
X 6
X 4
X 18
X 12
Note:
If you plan to assemble raised
bed on a hard surface, use
hacksaw to remove the spike of
each stake. Use these cut down
stakes for the base level only of
your raised garden.
Trim stake spike with
hacksawfor use indoor
or on hard surfaces
Four-Way Joint:
The Four-Way Joint is
comprised of two
pieces (A), which when
stacked, form the
complete bracket (B).
A B

Joint requires both
pieces of 4-way bracket
Joint requires one
piece of 4-way
bracket
Customer Service: 1800-914-9835 | su[email protected]
STEP 5: For the second level, place 4 (C) timbers on top of base level.
Place the remainder (A) and (B) timbers based on the
diagram below.
ASSEMBLY INSTRUCTIONS
(C) Timber
Connections
Use plugs (included)
to cover the holes on
both side of timbers
Use plugs to cover
the holes – two
plugs are required
per bracket (1 on
each side)
Use a Finishing
Cap to complete
the top level.
Use an Anchor
or Stacking Joint
for ground level
frames or borders.
Use only Stacking
Joints when
creatingadditional
levels.
When creating a
multi-level frame
use a Stacking
Joint.
Stacking Joints fit into
the tops of Anchor
Joints and other
Stacking
Joints
How the Joints Work
STEP 6: Insert a stake through the brackets
into the hole on the top of the stake
beneath it to lock the 2nd level in place.
STEP 7: Add the caps to each of the top
corner joints and plugs to cover the holes
on both side of timbers.