Front Runner KRTL015L Instruction Manual

1
LAND CRUISER 70
SLIMLINE II RACK
(1345mm x 2368mm )
KRTL015L
INSTALL TIME: 1 Hour
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR
VEHICLE. IMPROPER ATTACHMENT COULD RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY
INJURY OR DEATH TO YOU OR TO OTHERS. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT RUNNER
PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE
PRODUCTS FOR ADJUSTMENT, WEAR, AND DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND CAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO INSTALLATION OR USE. IF YOU DO
NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT
THOROUGHLY FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A
PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
Thank you for purchasing a Front Runner Slimline II Rack.
This Roof Rack consists of a kit that contains:
1. A Slimline II Tray
2. A mounting system specific to your vehicle
Before you start, take a moment and open all your boxes and gather the assembly instructions for the various
components.
This document will guide you through the assembly of the various mounting system components and assist you in fitting
the Slimline II Tray to your specific vehicle.
START HERE
READ ME FIRST
REV_A01

2
Assemble your Slimline II Rack
Refer to SLIMLINE (II TRAY UNIVERSAL ASSEMBLY INSTRUCTION Document RRSTUNI)
With your Rack in the upside down position (Product sticker should be upside down), fit the Legs to your
Slimline II Tray as illustrated below.
()
A
NOTE: DO NOT SLIDE THE RACK AND LEGS ACROSS THE ROOF! If there is a chance that you are going to
set the roof rack on to the roof, place some moving blankets and/or towels over the roof. If you must
lower the rack before it is in position, carefully set the Feet on the padded surface.
Once your Slimline II Roof Rack is fitted, ensure a 15mm clearance is maintained between the Wind
Deflector and the vehicles roof otherwise damage to the roof may occur. Bend the Wind Deflector by hand
if necessary.
REV_A01
Fit the LEGS
(Refer to LEG ASSEMBLY INSTRUCTION Document LASS1UNI)

3
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
MOUNT THE RACK TO YOUR VEHICLE
()Refer to LEG ASSEMBLY INSTRUCTION Document LASS1UNI
()
A Grab your friend and with one of you on each side of the Rack, flip the rack end over end (Prevents the
Hex Bolts from falling out the machines slots) so that the Legs are facing down. With the Wind Deflectors
facing forward, approach the vehicle from the rear lifting the Rack up and over the roof.
Position the Rack as far back as possible without it overhanging the rear of the vehicle. Bring the rack
down slowly making sure that the Legs go directly into the gutters of the vehicle.
Center the Rack left to right. Ensure that the Rack is level - front to back and left to right - before
fastening.
REV_A01
TAKE A TRIP
After your first adventure, check that all nuts, bolts, screws and fittings are tight. Re-tighten where
needed. You'll find a small amount of settling has happened.
Go on many more adventures, periodically checking all nuts, bolts, screws and fittings.
()
A
Front Runner can not recommend a maximum load carrying capacity. Please refer to your vehicle
manufacturer's recommendations.