Front Runner RRAC210 User manual

RRAC210_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS
front runner
RRAC210
ENG
1
Thank you for purchasing a Front Runner Rack Mounted Bottle Opener.
Before you start, take a moment to familiarize yourself with the Fitting Instructions and the included components.
Refer to Page 2 for a list of all the components, quantities and tools required.
READ ME !
IMPORTANT WARNING!
IT IS CRITICAL THAT ALL FRONT RUNNER PRODUCTS BE PROPERLY AND SECURELY ASSEMBLED AND ATTACHED TO YOUR VEHICLE. IMPROPER ATTACHMENT COULD
RESULT IN AN AUTOMOBILE ACCIDENT, AND COULD CAUSE SERIOUS BODILY INJURY OR DEATH. YOU ARE RESPONSIBLE FOR ASSEMBLING AND SECURING ALL FRONT
RUNNER PRODUCTS TO YOUR VEHICLE, CHECKING THE ATTACHMENTS PRIOR TO USE, AND PERIODICALLY INSPECTING THE PRODUCTS FOR ADJUSTMENT, WEAR AND
DAMAGE. THEREFORE, YOU MUST READ AND UNDERSTAND ALL OF THE INSTRUCTIONS AND PRECAUTIONS SUPPLIED WITH YOUR FRONT RUNNER PRODUCT PRIOR TO
INSTALLATION OR USE. IF YOU DO NOT UNDERSTAND ALL OF THE INSTRUCTIONS AND CAUTIONS, OR IF YOU HAVE NO MECHANICAL EXPERIENCE AND ARE NOT THOROUGHLY
FAMILIAR WITH THE INSTALLATION PROCEDURES, YOU SHOULD HAVE THE PRODUCT INSTALLED BY A PROFESSIONAL INSTALLER OR OTHER QUALIFIED PERSONNEL.
NOTE: Front Runner will not be responsible for any damage caused by the failure to install the product according to these instructions.
Please call us if you have any questions about the installation of this product.
Rack Mounted Bottle Opener

RRAC210_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS 2
TOOLS NEEDED
FIGURE 1.1
GET ORGANIZED
1
IN THE BOX
2
4mm
5mm
1 1 X Bottle Opener
2 1 X M8 x 12 Button Head Bolt
3 1 X M8 Thin Nut
4 1 X M8 Schnorr Washer
CHECK ONLINE FOR LATEST FITMENT GUIDE WWW.FRONTRUNNEROUTFITTERS.COM
4
3
1

RRAC210_REV_A00 © 2021 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE2
2.1
2.2
INSTALL OTHER VEHICLE AND RACK ACCESSORIES
4
Now's the time to visit your favorite Front Runner dealer in person or online.
Be sure to tag us. We love to see our gear in action! #FrontRunnerOutfitters #BornToRoam
Share your adventures on:
FINISH
3
Congratulations! You did it. Take a step back and admire your work!
FIT AND SECURE TO SLIMSPORT RACK
Preassemble the M8 x 12 Button Head
Bolt, M8 Schnorr Washer and M8 Thin Nut
(Items 2, 3 & 4) to the Bottle Opener (Item 1)
as shown.
Slide the assembly into the open end of the
slat before fully tightening the M8 Thin Nut
(Item 3).
FIT AND SECURE TO SLIMLINE II RACK
Loosen and remove the corner from the rack.
Preassemble the M8 x 12 Button Head Bolt,
M8 Schnorr Washer and M8 Thin Nut (Items
2, 3 & 4) to the Bottle Opener (Item 1) as
shown.
Slide the assembly into the open end of the
side profile before fully tightening the M8
Thin Nut (Item 3).
Refit the corner to the rack.
1
4
2
3
4mm
5mm
4mm
5mm
1
4
2
3