Furniture Solutions 19ELI User manual

H:112~82.5CM
D:85~ 164 .5CM
W:77CM
= Furniture Solutions =INSTRUCTION MANUAL
ELI LIFT RECLINER CHAIR
ITEM CODE: 19ELI
19ELI
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
1 of 11
Imported by Furniture Solutions (Aust) Pty
Ltd 10-16 Daisy St,
Revesby, NSW. 2212
www.furnituresolutions.com.au

PRE-ASSEMBLY PREPARATION
Avoid use of powered/battery drills.
Improper use of drills can irreversible damage fittings.
30
MINUTES
X2
ALLOW TIME PEOPLE REQUIRED
Before you start:
Choose a clean, level, spacious assembly area. Avoid hard surfaces that may
damage the product
1.
Take care when lifting. Product should be assembled as near as possible to
the point of use
2.
Ensure that you have all required contents for complete assembly
3.
4.Ensure to check all components for any damage before assembly.Please
report any damage found to below, if possible forward images of component
to below
5.Always read the assembly instructions carefully before beginning assembly.
6.Keep all hardware parts and packaging out of reach of small children.
7.Do not over tighten the screws and bolts as this may damage the threads
For any assistance with assembly or for missing parts please contact:
Place of purchase or
Furniture Solutions on below
Customer Service (Australia) Phone-1300 794 188
Email- customerser[email protected]
19ELI
2 of 11
Electrical Risk
Carefully plan your positioning of recliner
1. Keep cords clear of traffic area
2. Keep cords away from moister or liquids
3. Keep cords away from heat sources
Should you spill liquids on chair first switch off power at wall and take
the plug out.

PARTS LIST
1.Seat Cushion 2.Backrest Cushion
A
3.Chair Base
2
3
1
19ELI
3 of 11

To Assemble
Chair, chair base assembly
You will need
the help of another person thru this stage.
As indicated on diagram
place chair base [5] on a flat level surface. Take chair stem [C] insert
thicker
end into chair base, check that it is square. With help of another person pickup chair
seat
cushion and frame [1], locate hole in middle of frame under cushion, insert squarely onto
chair
and stem as indicated in diagram, check that it is fitted correctly should be no
movement in lower frame. Move to backrest assembly
3
1
19ELI
4 of 11

ASSEMBLY IS COMPLETE
19ELI
5 of 11

5
6
5
Press the button to lift the chair
6
Press the button to get down to original
position
19ELI
6 of 11
FEATURE’S
AND OPERA
TING OF RE
CLINER
HINTS & TIPS
Some buttons have more than one function
By holding onto button function will move
form one to the other.

Feature of Recliner:
Adjustment of head rest:
Internal Adjustable head rest for variable positions.
Please review diagrams below before operating headrest function.
19ELI
19ELI
19ELI
19ELI
7 of 11

CARE AND
MAINTENANCE
Varieties
of materials are used in construction of “Recliner” furniture range, Such as Stainless
Steel;
Nickel plated steel; Chrome plated steel; Powder coated steel; Timber, Leather, PU
synthetic fabric
& a variety fabrics.
All
will require some form of maintenance to extend the life of finishes and general appearance.
Please
see below instruction unique to your chosen model.
Leather Covering;
Keep dust free at all times.
Regular use a damp soft clean cloth and wipe down leather.
Pay special attention to areas where skin touchers leather. IE : Armrest Pads, Headrest, front
section of chair and footrest tops.
Please clean up spills immediately. Ensure to dry properly before use.
Periodic Leather Cleaning;
Every 3-4 months you need to give leather a good clean to remove excess body oils.
Please purchase a propriety leather cleaner and follow all directions indicated on packaging.
You could also purchase a leather conditioner/protector to complement the leather after a
good clean.
Frequency of periodic cleaning can vary due to colour of leather, use and environment.
A chair used 2 hours a day will require less cleaning than a chair used 8 hours a day.
Areas of high humidity will require more cleaning than areas of low humidity.
Professional Cleaning;
Even the most diligent house keeper cannot always prevent leather from aging or looking tired.
We recommend you use the services of a reputable leather cleaning service when your cleaning
does not appear to make a difference in appearance.
Things to know about leather;
The surface of leather can be affected by chemicals used in hair spray, gel, mousse, perfume,
deodorants, some medications, alcohol and dye transference from clothing. Please factor this
into your cleaning regime.
Nickel Plated Base;
Please remove dust and grit on metal as required.
When grease stains and tarnish begin to appear, you’ll need to clean off your plating. By
washing first with warm water, using a metal cleaner for persistent blemishes, and then
polishing, you will keep your nickel plating strong and lustrous for years to come.
19ELI
8 of 11

19BOS
9 of 11

SAFETY
WARNINGS AND ADVICE
Notices and Advice
Please
be advised that products are limited in design for residential use only and are not
suitable for commercial
use.
Please be advised that materials used in your furniture are not impervious to neglect, acts
of god, abuse, alcohol spills, improper use of chemicals such as bleach or any solvent based
products.
Please be advised that heat sources such as direct sunlight, log fires, heaters and air
conditioners can have adverse affects on your furniture.
Please be advised that fitting, bolts, nuts and or screws should be checked periodically to
ensure they have not loosened over time. Remember do not overtighten.
Please be advised coverings are not animal proof. Claws can scratch covering & saliva is
acidic and can damage finish of covering.
DO NOT
•Place in direct sunlight.
•Place in close proximity to open flame or heaters.
•Place in direct line of air conditioning ducting.
•Leave spills or food on sofa clean off immediately
•Pull loose thread, cut them instead.
•Sit or lean on arms
•Stand on chair
Safety warnings
•DO NOT:
•drop, drag
always with the help of another person lift and place, to avoid damage to floor
surface & base of recliner chair.
•Sit on arms or back when upright, this could damage internal mechanism.
•Fold mechanism with linen or cushions on sofa.
•Pull loose thread, cut them instead.
•Jump, flop or stand on sofa.
•Always release both glide handles before you attempt to move into upright position.
•Ensure swivel mechanism on chair base is clear of loose threads, long carpet fibre’s or
simular items
19ELI
10 of 11