FURNITUREBOX BELGRAVIA CHAIR User manual

BELGRAVIA CHAIR
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/belgravia-chair
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
MAXIMUM
CAPACITY 130Kg
30 MINUTE
BUILD
ONE
PERSON

Follow us on Instagram
@furniturebox_uk
STEP 1
Place the back and seat cushion part [A] upside down over the
edge of a stable table to work on.
Attach the Front Leg [B] to the front corner of the Seat Cushion
Frame [A] by using Lock Washer [2] followed by Flat Washer [3]
and then slotting Short Bolt [1] through washers and hole. Secure
with Allen Key [4].
Attach the Back Legs [C] to the back corner block of Seat Cushion
Frame [A] by using Lock Washer [2] followed by Flat Washer [3]
and then slotting Short Bolt [1] through washers and hole. Secure
with Allen Key [4]. Do not fully tighten all bolts

www.furniturebox.co.uk
STEP 2
Turn the chair to upright position
and place it on at surface. Adjust
legs so that Chair is level and does
not wobble. Fully tighten all Bolts at
this time with Allen Key [4]. Do not
over tighten. Your chair is now ready
to use.
FULL ASSEMBLY INSTRUCTIONS

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.