FURNITUREBOX MAYFAIR User manual

MAYFAIR TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/mayfair
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 1
Put the pieces on a soft at
surface e.g. a carpet to avoid
scratching or bumping. Insert part
4 (Stainless Steel poles) into the
assembly holes of part 3 (the high
gloss legs). Keep the direction of
the parts as shown.
STEP 2
Using the (part J) allen key tighen the
bolt (part G) and washer (part 1), (part
K) onto the table connecting board
(part 2) as shown. Please note 2 of
these bolts/washers will attach onto
the stainless steel poles as shown on
the table legs. Install 2 x part C onto
piece 5 and add to the table frame.

www.furniturebox.co.uk
STEP 3
Fix part F and part A as shown to
ensure the stability of the table.
STEP 4
Connect part 5 to the
bottom of the table legs
as shown using part E, I,
K and D. Insert the table
feet (part B) as shown.
Please note the height of
the table can be adjusted
using these feet.
FULL ASSEMBLY INSTRUCTIONS
STEP 5
Attach the connecting
board (part 2) to the
table top (part 1) using
bolts (part G) and
washers (part I).
STEP 6
ATTENTION: Using two
people turn the table over
and assembly is complete

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.