FURNITUREBOX OSLO OFFICE CHAIR User manual

OSLO OFFICE CHAIR
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/osloofce
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
45 MINUTE
BUILD MAXIMUM
CAPACITY
200Kg
TWO
PERSON

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clean, at, soft surface to avoid any bumps or scratches.
Attach the seat riser mechanism [B] to the chair seat [A]. Align the
pre-drilled holes and connect using 4x washers [G] followed by 4 x
bolts [F]. Tighten with Allen key [H].

STEP 2
Attach the 5x castor wheels [E] to the legs [D] - these will pop into
place. Then snap leg cap [I] to the top of the legs and leg base cap [J]
to the bottom of the legs.
www.furniturebox.co.uk
STEP 3
Connect the hydraulic
lift mechanism [C] to the
chair leg. Part [C] will drop
into the hole in the leg cap
[I]. Remember to remove
the cap from the top of
the hydraulic lift.

Follow us on Instagram
@furniturebox_uk
STEP 4
Align the seat riser
[B] (which should be
attached to your seat as
per step 1) with the top of
the hydraulic lift [C] and
lower the seat onto it.
STEP 5
Check stability. Your
chair is now ready to use!