FURNITUREBOX REGENT User manual

REGENT
CONSOLE TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/regent-console
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD
GLASS
x2
x2

Follow us on Instagram
@furniturebox_uk
STEP 2
Flip coffee table frame right
way up, onto its feet.
Add 4 x non-slip pads [D] to the
top edge of the table frame.
Add 4 x non-slip pads [E] to the
inner lip/edge of the bottom
frame (check the illustration for
location)
ATTENTION: Then, carefully and
with help, lower glass top shelf
[3] onto the top of the table and
lower bottom shelf [4] onto the
inner ledge of bottom frame.
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches.
Connect the 2 x rectangular
frames [1] to the 2 x X-shaped
end frames [2] by carefully
aligning and slotting the
upright bars of the rectangular
frames into the hollow tubes
on the X-frames.
Secure using 2 x washer [A]
followed by 2 x screw [B] at
the top and bottom of each
upright on the frame. Tighten
using Allen key [C].

www.furniturebox.co.uk
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Check stability. Your
console table is now
ready to use.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.