FURNITUREBOX MODICA User manual

MODICA
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/modica
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD
GLASS

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to avoid bumps or
scratches.
Lay table top [1] on oor, with metal rectangles
facing up.
Screw bolt rods [C] into the metal discs.
Align stands [2 and 3] over bolt rods and carefully
lower into place.
Secure using washer [B] followed by nut [D] for
each bolt rod. Tighten using spanner [F].

www.furniturebox.co.uk
STEP 2
Attach base to stands. Line up holes in base
[4] with the holes in the stands.
Secure with washer [B] followed by screw
[A] into each hole (6 in total).
Tighten with Allen key [E}
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Carefully, and with help,
ip your table correct
side up, so it sits on its
legs. Check stability.
Your table is now ready
to use.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.