FURNITUREBOX ALMA User manual

ALMA BEDSIDE TABLE
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/alexa-bedside
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
MAXIMUM
CAPACITY 25Kg
45 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 2
Connect the side board (3),
(4) with the bottom board
(2) use the ling screws (E).
Connect the back board (5)
with the side board (3), (4)
and the bottom board (2)
together.
STEP 1
Put the pieces on the soft
at surface e.g. a carpet to
avoid scratching. Make sure
that you have all pieces and
components ready to build the
bedside table.
Insert Cam screw (A) and
wooden dowel (C) into the
corresponding hole at the top
board (1) , and insert wooden
dowel (C) into corresponding
hole of the bottom board (2)

www.furniturebox.co.uk
STEP 3
Assembly the top board
(1) with the side boards
(3) (4) and then the
back board (5). Tighten
using cam lock nuts
(B). Install the wooden
leg (G) and stick on the
waterproof feet pad (H).
STEP 4
Assemble the drawers, connect the drawer front
piece (6), drawer side piece (7), (8) and bottom
drawer piece (9), tighten with screws (D).
ATTENTION: Be careful not to overload drawers.
FULL ASSEMBLY INSTRUCTIONS
STEP 5
Install the assembled drawers in the
assembled cabinet.
Then use fastening clips to secure
cabinet back with 16mm screws.
Assembly complete.
ATTENTION: The Anti Tipping Kit MUST
be used to connect the cabinet to the
wall to prevent tipping over.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.