FURNITUREBOX ALEXIS User manual

ALEXIS
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips, advice
and assembly video or visit
furniturebox.co.uk/club/alexis-coffee
SCAN ME

• Check you have all the components and
tools listed.
• Remove all fttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from
the work area, small parts could cause
choking if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly.
In some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
TWO
PERSON
GLASS MAXIMUM
CAPACITY 100Kg
30 MINUTE
BUILD

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to
avoid bumps or scratches.
Attach 1x top panel [1] to side
panel [2] :
Use 1x rod [A] and 1 x dowel [B]
at either end of side panel, as
per diagram.
Attach 1 x support panel [4] top
top panel, using 2 x cam bolts
[C2] and lock into place using 2
x cam locks [C1].
Repeat above process with
other top, side and support
panel, so you have two halves.
STEP 2
Attach bottom panel [3]:
Add 4x dowel rods [A} to side panels as
per diagram.
Add 4x cam bolts and locks [C1 and C2}
to support panels as per diagram.
Align bottom panel 3 and gently tap into
place. Lock support panels into place by
twisting cam locks [C1} to tighten.
Secure bottom panel by adding 1x
washer [D] and 1x nut [E] to each corner,
and tightening with spanner [F]
BE CAREFUL NOT TO OVER TIGHTEN
AND SPLIT THE WOOD.

www.furniturebox.co.uk
STEP 4
Flip coffee table over.
Add plastic pad [I] to
inner runner edge of top
panel.
FULL ASSEMBLY INSTRUCTIONS
STEP 3
Add table feet:
Add 1 x table foot [G] to each
corner of bottom panel using
4x screws [H]

Follow us on Instagram
@furniturebox_uk
STEP 5
Carefully, and with help, lower
glass table top [5} into gap so
that it rests on the inner runner
edges of the two top panels.
STEP 6
Your coffee table is now
complete.

www.furniturebox.co.uk

The cushions (foam inserts and
covers) are not covered by the guarantee.