FURNITUREBOX TAHITI User manual

TAHITI CHAIR
ASSEMBLY GUIDE
www.furniturebox.co.uk
Scan QR code for more tips,
advice and assembly video or visit
furniturebox.co.uk/club/tahitichair
SCAN ME

• Check you have all the components and
tools listed.
• Remove all ttings from the plastic bags
and separate them into their groups.
• We do not recommend the use of power
drills/drivers for inserting screws, as this
could damage the unit. Only use hand
screwdrivers and Allen keys.
• Keep children and animals away from the
work area, small parts could cause choking
if swallowed.
• Make sure you have enough space to
layout the parts before starting.
• Assemble the item as close to its nal
position (in the same room) as possible.
• Do not overtighten the nuts to avoid
causing damage to the threads.
Important - Please read these instructions fully before starting assembly
SAFETY AND
CARE ADVICE
!
NO POWER TOOLS
Follow us on Instagram
@furniturebox_uk
• Only clean using a damp
cloth and mild detergent,
do no use bleach or
abrasive cleaners.
• From time to time check
that there are no loose
screws on this unit
• This product should not be
discarded with household
waste. Take to your local
authority waste disposal
centre
SAFETY AND CARE ADVICE

www.furniturebox.co.uk
PLEASE CHECK CAREFULLY AND MAKE SURE YOU HAVE ALL
FITTINGS AND TOOLS LISTED BELOW BEFORE YOU START.
NOTE: The quantities above are the correct amount to complete the assembly. In
some cases more ttings may be supplied than are required.
IMPORTANT INFORMATION
30 MINUTE
BUILD MAXIMUM
CAPACITY
120Kg
TWO
PERSON

Follow us on Instagram
@furniturebox_uk
STEP 1
Use a clear, at, soft surface to avoid bumps or scratches. Lay all your
components and xings out. Note: we recommend you don’t fully
tighten any of the bolts until everything is fully assembled.
First, assemble the footrest.
Attach 2x leg pieces [H] to the footrest [G] using 4x washer + bolts [aa]
on each leg - 8 in total. Fully tighten the bolts with Allen key [bb]. Flip
footrest over to stand on its feet and check stability. Add cushion [I]
and secure with ties.

www.furniturebox.co.uk
STEP 2
Next, assemble the chair.
Attach the leg frame [B] to
the chair seat [A] using 4x
washers + bolts [aa]. Fully
tighten with Allen key [bb].
Flip chair onto its feet and
check stability. Add cushion
[C].
Your chair and footrest are
now ready to use!